[PATCH v2 0/3] Reduce lcm_reset to DSI LP11 send cmd time

[xinlei.lee at mediatek.com]

From: Xinlei Lee <xinlei.lee at mediatek.com>

The panel spec stipulates that after lcm_reset is pulled high, cmd
should be sent to initialize the panel. Within the allowable range of
the DSI spec, this time needs to be reduced to avoid panel exceptions.

Base on the branch of linus/master v6.2.

Change since v1:
1. Added fine-tuning panel power sequence modification.

Xinlei Lee (3):
  drm/mediatek: dsi: Reduce the time of dsi from LP11 to sending cmd
  drm/panel: boe-tv101wum-nl6: Reduce lcm_reset to send initial code
    time
  drm/panel: boe-tv101wum-nl6: Fine tune the panel power sequence

 drivers/gpu/drm/mediatek/mtk_dsi.c             | 2 +-
 drivers/gpu/drm/panel/panel-boe-tv101wum-nl6.c | 7 ++++++-
 2 files changed, 7 insertions(+), 2 deletions(-)

-- 
2.18.0