[PATCH 1/2] drm/mediatek: dsi: Reduce the time of dsi from LP11 to sending cmd

AngeloGioacchino Del Regno angelogioacchino.delregno at collabora.com
Mon Jan 9 03:26:24 PST 2023


Il 06/01/23 04:05, xinlei.lee at mediatek.com ha scritto:
> From: Xinlei Lee <xinlei.lee at mediatek.com>
> 
> According to Figure 16 Turnaround Procedure on page 36 in [1], you
> can see the status of LP-00 -> LP10 -> LP11. This state can correspond
> to the state of DSI from LP00 -> LP11 in mtk_dsi_lane_ready function
> in mtk_dsi.c.
> 
> LP-00 -> LP10 -> LP11 takes about 2*TLPX time (refer to [1] page 51
> to see that TLPX is 50ns).
> 
> The delay at the end of the mtk_dsi_lane_ready function should be
> greater than the 2*TLPX specified by the DSI spec, and less than
> the time specified by the DSI_RX (generally 6ms to 40ms), to avoid
> problems caused by the RX specification.
> 
> [1]:mipi_D-PHY_specification_v1-1
> 
> Fixes: 39e8d062b03c ("drm/mediatek: Keep dsi as LP00 before dcs cmds transfer")
> Signed-off-by: Xinlei Lee <xinlei.lee at mediatek.com>

Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno at collabora.com>





More information about the Linux-mediatek mailing list