[PATCH v14 0/6] Add LVTS Thermal Architecture

[Daniel Lezcano]

On 09/02/2023 11:56, bchihi at baylibre.com wrote:
> From: Balsam CHIHI <bchihi at baylibre.com>
> 
> The LVTS (Low Voltage Thermal Sensor) driver is capable of monitoring
> multiple hot points. For that, it contains 7 thermal control blocks
> dedicated to specific devices on the die. Each control block can handle
> up to 4 sensors.
> 
> The thermal controller supports several interrupts. One for the cold
> trip point, the hot trip point, the return to the normal trip point,
> and a specific programmable trip point to monitor the temperature
> dynamically.
> 
> The temperature measurement can be done in two ways, the immediate mode
> where the temperature read is instantaneous and the filtered mode where
> the controller uses, by configuration, an average of a set of values
> removing the minimum and the maximum.
> 
> Finally, it is composed of 2 finite-state machines responsible for
> the state of the temperature (cold, hot, hot 2 normal, hot hot),
> the triggering of the interrupts, and the monitoring of the temperature.
> 
> As requested, the thermal driver has been reworked to reduce
> the complexity of the code. At this time, the 4 little CPUs and
> the 4 big CPUs are supported by the thermal driver.They are described
> in a data structure and more devices can be added later.
> The calibration routine has been simplified also.
> 
> The series provide the following changes:
>   - Move the Mediatek drivers inside a dedicated folder as their number
>     is increasing
>   - Add the DT bindings for the controller
>   - Add the efuse node for the mt8195
>   - The LVTS driver
>   - The thermal zones description in the DT

Applied patch 1,2 and 4 for v6.3

Patches 5 and 6 should go through the Mediatek tree.

Thanks!

   -- Daniel


-- 
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog