[PATCH v8 00/10] Enable HS-G5 support on SM8550

[Martin K. Petersen]

On Sat, 02 Dec 2023 04:36:06 -0800, Can Guo wrote:

> This series enables HS-G5 support on SM8550.
> 
> This series is rebased on below changes from Mani -
> https://patchwork.kernel.org/project/linux-scsi/patch/20230908145329.154024-1-manivannan.sadhasivam@linaro.org/
> https://patchwork.kernel.org/project/linux-scsi/patch/20230908145329.154024-2-manivannan.sadhasivam@linaro.org/
> 
> This series is tested on below HW combinations -
> SM8550 MTP + UFS4.0
> SM8550 QRD + UFS3.1
> SM8450 MTP + UFS3.1 (for regression test)
> SM8350 MTP + UFS3.1 (for regression test)
> 
> [...]

Applied to 6.8/scsi-queue, thanks!

[01/10] scsi: ufs: host: Rename structure ufs_dev_params to ufs_host_params
        https://git.kernel.org/mkp/scsi/c/fa3dca8251c4
[02/10] scsi: ufs: ufs-qcom: No need to set hs_rate after ufshcd_init_host_param()
        https://git.kernel.org/mkp/scsi/c/dc604b4c9d60
[03/10] scsi: ufs: ufs-qcom: Setup host power mode during init
        https://git.kernel.org/mkp/scsi/c/55820a7f2cb9
[04/10] scsi: ufs: ufs-qcom: Allow the first init start with the maximum supported gear
        https://git.kernel.org/mkp/scsi/c/743e1f596ccc
[05/10] scsi: ufs: ufs-qcom: Limit HS-G5 Rate-A to hosts with HW version 5
        https://git.kernel.org/mkp/scsi/c/9d8528a833fc
[06/10] scsi: ufs: ufs-qcom: Set initial PHY gear to max HS gear for HW ver 4 and newer
        https://git.kernel.org/mkp/scsi/c/0bd3cb895d19
[07/10] scsi: ufs: ufs-qcom: Check return value of phy_set_mode_ext()
        https://git.kernel.org/mkp/scsi/c/a68abdadfe13
[08/10] scsi: ufs: ufs-qcom: Add support for UFS device version detection
        https://git.kernel.org/mkp/scsi/c/dc7c948d74e1

-- 
Martin K. Petersen	Oracle Linux Engineering