[PATCH v2 1/3] PCI: mediatek: Allocate MSI address with dmam_alloc_coherent()

[Jianjun Wang]

Use dmam_alloc_coherent() to allocate the MSI address, instead of using
virt_to_phys().

Signed-off-by: Jianjun Wang <jianjun.wang at mediatek.com>
---
 drivers/pci/controller/pcie-mediatek.c | 24 ++++++++++++++++--------
 1 file changed, 16 insertions(+), 8 deletions(-)

diff --git a/drivers/pci/controller/pcie-mediatek.c b/drivers/pci/controller/pcie-mediatek.c
index 66a8f73296fc..2fb9e44369f8 100644
--- a/drivers/pci/controller/pcie-mediatek.c
+++ b/drivers/pci/controller/pcie-mediatek.c
@@ -178,6 +178,7 @@ struct mtk_pcie_soc {
  * @phy: pointer to PHY control block
  * @slot: port slot
  * @irq: GIC irq
+ * @msg_addr: MSI message address
  * @irq_domain: legacy INTx IRQ domain
  * @inner_domain: inner IRQ domain
  * @msi_domain: MSI IRQ domain
@@ -198,6 +199,7 @@ struct mtk_pcie_port {
 	struct phy *phy;
 	u32 slot;
 	int irq;
+	dma_addr_t msg_addr;
 	struct irq_domain *irq_domain;
 	struct irq_domain *inner_domain;
 	struct irq_domain *msi_domain;
@@ -394,12 +396,10 @@ static struct pci_ops mtk_pcie_ops_v2 = {
 static void mtk_compose_msi_msg(struct irq_data *data, struct msi_msg *msg)
 {
 	struct mtk_pcie_port *port = irq_data_get_irq_chip_data(data);
-	phys_addr_t addr;
 
 	/* MT2712/MT7622 only support 32-bit MSI addresses */
-	addr = virt_to_phys(port->base + PCIE_MSI_VECTOR);
 	msg->address_hi = 0;
-	msg->address_lo = lower_32_bits(addr);
+	msg->address_lo = lower_32_bits(port->msg_addr);
 
 	msg->data = data->hwirq;
 
@@ -494,6 +494,14 @@ static struct msi_domain_info mtk_msi_domain_info = {
 static int mtk_pcie_allocate_msi_domains(struct mtk_pcie_port *port)
 {
 	struct fwnode_handle *fwnode = of_node_to_fwnode(port->pcie->dev->of_node);
+	void *msi_vaddr;
+
+	msi_vaddr = dmam_alloc_coherent(port->pcie->dev, sizeof(dma_addr_t), &port->msg_addr,
+					GFP_KERNEL);
+	if (!msi_vaddr) {
+		dev_err(port->pcie->dev, "failed to alloc and map MSI address\n");
+		return -ENOMEM;
+	}
 
 	mutex_init(&port->lock);
 
@@ -501,6 +509,7 @@ static int mtk_pcie_allocate_msi_domains(struct mtk_pcie_port *port)
 						      &msi_domain_ops, port);
 	if (!port->inner_domain) {
 		dev_err(port->pcie->dev, "failed to create IRQ domain\n");
+		dmam_free_coherent(port->pcie->dev, sizeof(dma_addr_t), msi_vaddr, port->msg_addr);
 		return -ENOMEM;
 	}
 
@@ -508,6 +517,7 @@ static int mtk_pcie_allocate_msi_domains(struct mtk_pcie_port *port)
 						     port->inner_domain);
 	if (!port->msi_domain) {
 		dev_err(port->pcie->dev, "failed to create MSI domain\n");
+		dmam_free_coherent(port->pcie->dev, sizeof(dma_addr_t), msi_vaddr, port->msg_addr);
 		irq_domain_remove(port->inner_domain);
 		return -ENOMEM;
 	}
@@ -518,10 +528,8 @@ static int mtk_pcie_allocate_msi_domains(struct mtk_pcie_port *port)
 static void mtk_pcie_enable_msi(struct mtk_pcie_port *port)
 {
 	u32 val;
-	phys_addr_t msg_addr;
 
-	msg_addr = virt_to_phys(port->base + PCIE_MSI_VECTOR);
-	val = lower_32_bits(msg_addr);
+	val = lower_32_bits(port->msg_addr);
 	writel(val, port->base + PCIE_IMSI_ADDR);
 
 	val = readl(port->base + PCIE_INT_MASK);
@@ -588,7 +596,7 @@ static int mtk_pcie_init_irq_domain(struct mtk_pcie_port *port,
 	if (IS_ENABLED(CONFIG_PCI_MSI)) {
 		ret = mtk_pcie_allocate_msi_domains(port);
 		if (ret)
-			return ret;
+			dev_warn(dev, "no MSI supported, only INTx available\n");
 	}
 
 	return 0;
@@ -732,7 +740,7 @@ static int mtk_pcie_startup_port_v2(struct mtk_pcie_port *port)
 	val &= ~INTX_MASK;
 	writel(val, port->base + PCIE_INT_MASK);
 
-	if (IS_ENABLED(CONFIG_PCI_MSI))
+	if (IS_ENABLED(CONFIG_PCI_MSI) && port->msi_domain)
 		mtk_pcie_enable_msi(port);
 
 	/* Set AHB to PCIe translation windows */
-- 
2.18.0