[RFC PATCH v2 2/8] phy: add driver for MediaTek pextp 10GE SerDes PHY

Maxime Chevallier maxime.chevallier at bootlin.com
Wed Dec 6 01:44:48 PST 2023


Hello Daniel,

On Wed, 6 Dec 2023 01:44:08 +0000
Daniel Golle <daniel at makrotopia.org> wrote:

> Add driver for MediaTek's pextp 10 Gigabit/s Ethernet SerDes PHY which
> can be found in the MT7988 SoC.
> 
> The PHY can operates only in PHY_MODE_ETHERNET, the submode is one of
> PHY_INTERFACE_MODE_* corresponding to the supported modes:
> 
>  * USXGMII
>  * 10GBase-R
>  * 5GBase-R
>  * 2500Base-X
>  * 1000Base-X
>  * Cisco SGMII (MAC side)
> 
> In order to work-around a performance issue present on the first of
> two PEXTP present in MT7988 special tuning is applied which can be
> selected by adding the mediatek,usxgmii-performance-errata property to
> the device tree node.
> 
> There is no documentation what-so-ever for the pextp registers and
> this driver is based on a GPL licensed implementation found in
> MediaTek's SDK.
> 
> Signed-off-by: Daniel Golle <daniel at makrotopia.org>
> ---

 [...]

> +
> +static int mtk_pextp_power_on(struct phy *phy)
> +{
> +	struct mtk_pextp_phy *pextp = phy_get_drvdata(phy);
> +	int ret;
> +
> +	ret = clk_prepare_enable(pextp->clk[0]);
> +	if (ret)
> +		return ret;
> +
> +	return clk_prepare_enable(pextp->clk[1]);
> +}

clk_bulk operations could be used here

> +static int mtk_pextp_power_off(struct phy *phy)
> +{
> +	struct mtk_pextp_phy *pextp = phy_get_drvdata(phy);
> +
> +	clk_disable_unprepare(pextp->clk[1]);
> +	clk_disable_unprepare(pextp->clk[0]);
> +
> +	return 0;
> +}

Here

> +static const struct phy_ops mtk_pextp_ops = {
> +	.power_on	= mtk_pextp_power_on,
> +	.power_off	= mtk_pextp_power_off,
> +	.set_mode	= mtk_pextp_set_mode,
> +	.reset		= mtk_pextp_reset,
> +	.owner		= THIS_MODULE,
> +};
> +
> +static int mtk_pextp_probe(struct platform_device *pdev)
> +{
> +	struct device_node *np = pdev->dev.of_node;
> +	struct phy_provider *phy_provider;
> +	struct mtk_pextp_phy *pextp;
> +	struct phy *phy;
> +
> +	if (!np)
> +		return -ENODEV;
> +
> +	pextp = devm_kzalloc(&pdev->dev, sizeof(*pextp), GFP_KERNEL);
> +	if (!pextp)
> +		return -ENOMEM;
> +
> +	pextp->base = devm_of_iomap(&pdev->dev, np, 0, NULL);
> +	if (!pextp->base)
> +		return -EIO;
> +
> +	pextp->dev = &pdev->dev;
> +	pextp->clk[0] = devm_clk_get(&pdev->dev, "topxtal");
> +	if (IS_ERR(pextp->clk[0]))
> +		return PTR_ERR(pextp->clk[0]);
> +
> +	pextp->clk[1] = devm_clk_get(&pdev->dev, "xfipll");
> +	if (IS_ERR(pextp->clk[1]))
> +		return PTR_ERR(pextp->clk[1]);

And here as well.

Thanks,

Maxime




More information about the Linux-mediatek mailing list