[RFC PATCH v2 net-next 13/14] net: dsa: mt7530: fix port capabilities for MT7988

[arinc9.unal at gmail.com]

From: Arınç ÜNAL <arinc.unal at arinc9.com>

On the switch on the MT7988 SoC, there are only 4 PHYs. That's port 0 to 3.
Set the internal phy cases to '0 ... 3'.

There's no need to clear the config->supported_interfaces bitmap before
reporting the supported interfaces as all bits in the bitmap will already
be initialized to zero when the phylink_config structure is allocated.
There's no code that would change the bitmap beforehand. Remove it.

Signed-off-by: Arınç ÜNAL <arinc.unal at arinc9.com>
---
 drivers/net/dsa/mt7530.c | 4 +---
 1 file changed, 1 insertion(+), 3 deletions(-)

diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
index 6fbbdcb5987f..903e39b7b772 100644
--- a/drivers/net/dsa/mt7530.c
+++ b/drivers/net/dsa/mt7530.c
@@ -2545,10 +2545,8 @@ static void mt7531_mac_port_get_caps(struct dsa_switch *ds, int port,
 static void mt7988_mac_port_get_caps(struct dsa_switch *ds, int port,
 				     struct phylink_config *config)
 {
-	phy_interface_zero(config->supported_interfaces);
-
 	switch (port) {
-	case 0 ... 4: /* Internal phy */
+	case 0 ... 3: /* Internal phy */
 		__set_bit(PHY_INTERFACE_MODE_INTERNAL,
 			  config->supported_interfaces);
 		break;
-- 
2.37.2