[PATCH net-next 1/3] dt-bindings: net: dsa: mt7530: replace label = "cpu" with proper checks

[Vladimir Oltean]

The fact that some DSA device trees use 'label = "cpu"' for the CPU port
is nothing but blind cargo cult copying. The 'label' property was never
part of the DSA DT bindings for anything except the user ports, where it
provided a hint as to what name the created netdevs should use.

DSA does use the "cpu" port label to identify a CPU port in dsa_port_parse(),
but this is only for non-OF code paths (platform data).

The proper way to identify a CPU port is to look at whether the
'ethernet' phandle is present.

Signed-off-by: Vladimir Oltean <vladimir.oltean at nxp.com>
---
 .../devicetree/bindings/net/dsa/mediatek,mt7530.yaml | 12 +++---------
 1 file changed, 3 insertions(+), 9 deletions(-)

diff --git a/Documentation/devicetree/bindings/net/dsa/mediatek,mt7530.yaml b/Documentation/devicetree/bindings/net/dsa/mediatek,mt7530.yaml
index f9e7b6e20b35..fa271ee16b5e 100644
--- a/Documentation/devicetree/bindings/net/dsa/mediatek,mt7530.yaml
+++ b/Documentation/devicetree/bindings/net/dsa/mediatek,mt7530.yaml
@@ -163,9 +163,7 @@ patternProperties:
         allOf:
           - $ref: dsa-port.yaml#
           - if:
-              properties:
-                label:
-                  const: cpu
+              required: [ ethernet ]
             then:
               required:
                 - phy-mode
@@ -187,9 +185,7 @@ $defs:
         patternProperties:
           "^(ethernet-)?port@[0-9]+$":
             if:
-              properties:
-                label:
-                  const: cpu
+              required: [ ethernet ]
             then:
               if:
                 properties:
@@ -215,9 +211,7 @@ $defs:
         patternProperties:
           "^(ethernet-)?port@[0-9]+$":
             if:
-              properties:
-                label:
-                  const: cpu
+              required: [ ethernet ]
             then:
               if:
                 properties:
-- 
2.34.1