[PATCH v3 5/6] dt-bindings: net: dsa: make reset optional and add rgmii-mode to mt7531

Frank Wunderlich frank-w at public-files.de
Sat May 7 23:24:37 PDT 2022


Am 7. Mai 2022 22:01:22 MESZ schrieb Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org>:
>On 07/05/2022 19:04, Frank Wunderlich wrote:
>> From: Frank Wunderlich <frank-w at public-files.de>
>> 
>> Make reset optional as driver already supports it, 
>
>I do not see the connection between hardware needing or not needing a
>reset GPIO and a driver supporting it or not... What does it mean?

My board has a shared gpio-reset between gmac and switch, so both will resetted if it is asserted. Currently it is set to the gmac and is aquired exclusive. Adding it to switch results in 2 problems:

- due to exclusive and already mapped to gmac, switch driver exits as it cannot get the reset-gpio again.
- if i drop the reset from gmac and add to switch, it resets the gmac and this takes too long for switch to get up. Of course i can increase the wait time after reset,but dropping reset here was the easier way.

Using reset only on gmac side brings the switch up.

>> allow port 5 as
>> cpu-port 
>
>How do you allow it here?

Argh, seems i accidentally removed this part and have not recognized while checking :(

It should only change description of reg for ports to:

"Port address described must be 5 or 6 for CPU port and from 0 to 5 for user ports."

regards Frank



More information about the Linux-mediatek mailing list