[PATCH 25/38] ASoC: tscs454: Add endianness flag in snd_soc_component_driver

[Charles Keepax]

The endianness flag is used on the CODEC side to specify an
ambivalence to endian, typically because it is lost over the hardware
link. This device receives audio over an I2S DAI and as such should
have endianness applied.

A fixup is also required to use the width directly rather than relying
on the format in hw_params, now both little and big endian would be
supported. It is worth noting this changes the behaviour of S24_LE to
use a word length of 24 rather than 32. This would appear to be a
correction since the fact S24_LE is stored as 32 bits should not be
presented over the bus.

Signed-off-by: Charles Keepax <ckeepax at opensource.cirrus.com>
---
 sound/soc/codecs/tscs454.c | 12 ++++++------
 1 file changed, 6 insertions(+), 6 deletions(-)

diff --git a/sound/soc/codecs/tscs454.c b/sound/soc/codecs/tscs454.c
index b34a8b5164848..38622bc247fc8 100644
--- a/sound/soc/codecs/tscs454.c
+++ b/sound/soc/codecs/tscs454.c
@@ -3120,18 +3120,17 @@ static int set_aif_sample_format(struct snd_soc_component *component,
 	unsigned int width;
 	int ret;
 
-	switch (format) {
-	case SNDRV_PCM_FORMAT_S16_LE:
+	switch (snd_pcm_format_width(format)) {
+	case 16:
 		width = FV_WL_16;
 		break;
-	case SNDRV_PCM_FORMAT_S20_3LE:
+	case 20:
 		width = FV_WL_20;
 		break;
-	case SNDRV_PCM_FORMAT_S24_3LE:
+	case 24:
 		width = FV_WL_24;
 		break;
-	case SNDRV_PCM_FORMAT_S24_LE:
-	case SNDRV_PCM_FORMAT_S32_LE:
+	case 32:
 		width = FV_WL_32;
 		break;
 	default:
@@ -3326,6 +3325,7 @@ static const struct snd_soc_component_driver soc_component_dev_tscs454 = {
 	.num_dapm_routes = ARRAY_SIZE(tscs454_intercon),
 	.controls =	tscs454_snd_controls,
 	.num_controls = ARRAY_SIZE(tscs454_snd_controls),
+	.endianness = 1,
 };
 
 #define TSCS454_RATES SNDRV_PCM_RATE_8000_96000
-- 
2.30.2