[RESEND v7 1/3] dt-bindings: mmc: mtk-sd: extend interrupts and pinctrls properties

[Axe Yang]

Hi Rob,

Thanks for your review.

On Sat, 2022-03-19 at 20:13 -0600, Rob Herring wrote:
> On Thu, 17 Mar 2022 18:12:13 +0800, Axe Yang wrote:
> > Extend interrupts and pinctrls for SDIO wakeup interrupt feature.
> > This feature allow SDIO devices alarm asynchronous interrupt to
> > host
> > even when host stop providing clock to SDIO card. An extra wakeup
> > interrupt and pinctrl states for SDIO DAT1 pin state switching are
> > required in this scenario.
> > 
> > Signed-off-by: Axe Yang <axe.yang at mediatek.com>
> > ---
> >  .../devicetree/bindings/mmc/mtk-sd.yaml       | 24
> > ++++++++++++++++++-
> >  1 file changed, 23 insertions(+), 1 deletion(-)
> > 
> 
> My bot found errors running 'make DT_CHECKER_FLAGS=-m
> dt_binding_check'
> on your patch (DT_CHECKER_FLAGS is new in v5.13):
> 
> yamllint warnings/errors:
> 
> dtschema/dtc warnings/errors:
> /builds/robherring/linux-dt-
> review/Documentation/devicetree/bindings/mmc/mtk-sd.yaml:
> properties:pinctrl-names: {'description': 'Should at least contain
> default and state_uhs. To support SDIO in-band wakeup, dat1 pin will
> be switched between GPIO mode and SDIO DAT1 mode, state_eint and
> state_dat1 are mandatory in this scenarios.', 'minItems': 2,
> 'maxItems': 4, 'items': [{'const': 'default'}, {'const':
> 'state_uhs'}, {'const': 'state_eint'}, {'const': 'state_dat1'}]}
> should not be valid under {'required': ['maxItems']}
> 	hint: "maxItems" is not needed with an "items" list
> 	from schema $id: http://devicetree.org/meta-schemas/items.yaml#
> /builds/robherring/linux-dt-
> review/Documentation/devicetree/bindings/mmc/mtk-sd.yaml: ignoring,
> error in schema: properties: pinctrl-names
> Documentation/devicetree/bindings/mmc/mtk-sd.example.dt.yaml:0:0: 
> /example-0/mmc at 11230000: failed to match any schema with compatible:
> ['mediatek,mt8173-mmc']
> 
> doc reference errors (make refcheckdocs):
> 
> See https://patchwork.ozlabs.org/patch/1606491
> 
> This check can fail if there are any dependencies. The base for a
> patch
> series is generally the most recent rc1.
> 
> If you already ran 'make dt_binding_check' and didn't see the above
> error(s), then make sure 'yamllint' is installed and dt-schema is up
> to
> date:
> 
> pip3 install dtschema --upgrade
> 
> Please check and re-submit.


I reproduced the error and already fix it in v8.

Regards,
Axe