[PATCH v2] Bluetooth: btmtksdio: Add in-band wakeup support

[AngeloGioacchino Del Regno]

Il 22/06/22 23:56, sean.wang at mediatek.com ha scritto:
> From: Sean Wang <sean.wang at mediatek.com>
> 
> Commit ce64b3e94919 ("Bluetooth: mt7921s: Support wake on bluetooth")
> adds the wake on bluethooth via a dedicated GPIO.
> 
> Extend the wake-on-bluetooth to use the SDIO DAT1 pin (in-band wakeup),
> when supported by the SDIO host driver.
> 
> Co-developed-by: Yake Yang <yake.yang at mediatek.com>
> Signed-off-by: Yake Yang <yake.yang at mediatek.com>
> Signed-off-by: Sean Wang <sean.wang at mediatek.com>
> ---
> v2: enhance the patch description and comments
> ---
>   drivers/bluetooth/btmtksdio.c | 8 ++++++++
>   1 file changed, 8 insertions(+)
> 
> diff --git a/drivers/bluetooth/btmtksdio.c b/drivers/bluetooth/btmtksdio.c
> index d6700efcfe8c..9d79c9107b3a 100644
> --- a/drivers/bluetooth/btmtksdio.c
> +++ b/drivers/bluetooth/btmtksdio.c
> @@ -118,6 +118,7 @@ MODULE_DEVICE_TABLE(sdio, btmtksdio_table);
>   #define BTMTKSDIO_FUNC_ENABLED		3
>   #define BTMTKSDIO_PATCH_ENABLED		4
>   #define BTMTKSDIO_HW_RESET_ACTIVE	5
> +#define BTMTKSDIO_INBAND_WAKEUP		6
>   
>   struct mtkbtsdio_hdr {
>   	__le16	len;
> @@ -1294,6 +1295,9 @@ static bool btmtksdio_sdio_wakeup(struct hci_dev *hdev)
>   		.wakeup_delay = cpu_to_le16(0x20),
>   	};
>   
> +	if (test_bit(BTMTKSDIO_INBAND_WAKEUP, &bdev->tx_state))
> +		return may_wakeup;
> +

Uhm... this flag is either *always* set, or *always not set*... and we decide that
during probe time... and we use it in just one function as well.

At this point, I would just avoid the addition of the BTMTKSDIO_INBAND_WAKEUP flag
and add a new function for handling the .wakeup() callback - something like:

static bool btmtksdio_sdio_inband_wakeup(struct hci_dev *hdev)
{
	struct btmtksdio_dev *bdev = hci_get_drvdata(hdev);

	return device_may_wakeup(bdev->dev);
}

static int btmtksdio_probe(...)
{
	.... code ....

	/*
	 * If SDIO controller supports wake on Bluetooth, sending a wakeon
	 * command is not necessary.
	 */
	if (device_can_wakeup(func->card->host->parent))
		hdev->wakeup = btmtksdio_sdio_inband_wakeup;
	else
		hdev->wakeup = btmtksdio_sdio_wakeup;

	.... etc ....
}

Regards,
Angelo