[PATCH 3/4] firmware: arm_scmi: Get detailed power scale from perf

[Lukasz Luba]

On 6/22/22 16:53, Sudeep Holla wrote:
> On Wed, Jun 22, 2022 at 03:58:01PM +0100, Lukasz Luba wrote:
>> In SCMI v3.1 the power scale can be in micro-Watts. The upper layers, e.g.
>> cpufreq and EM should handle received power values properly (upscale when
>> needed). Thus, provide an interface which allows to check what is the
>> scale for power values. The old interface allowed to distinguish between
>> bogo-Watts and milli-Watts only (which was good for older SCMI spec).
>>
> 
> Assuming you will take this as a series,
> 
> Acked-by: Sudeep Holla <sudeep.holla at arm.com>
> 

Thanks Sudeep for the ACKs!

Regards,
Lukasz