Aw: [RFC PATCH net-next] dt-bindings: net: dsa: mediatek,mt7530: completely rework binding

[Frank Wunderlich]

> Gesendet: Dienstag, 26. Juli 2022 um 14:24 Uhr
> Von: "Arınç ÜNAL" <arinc.unal at arinc9.com>

Hi, 

> To Frank:
> Let me know if MII bindings for port 5 and 6 on MT7531 are okay.

I ack krzysztof, that the change is really huge and it is hard to understand what exactly is changed and why. So please split. I have converted 
it to yaml, but not have changed the logic itself. I guess you know the switch better than me.

> Does your recent patch for MT7531 make it possible to set any port for CPU,
> including user ports? For now, I put a rule to restrict CPU ports to 5 and
> 6, as described on the description of dsa port reg property.

i only know that port 5 and 6 are possible, not about the other ports. Afair there was a check if port 5 or 6 (followed by available modes
like rgmii, trgmii or sgmii) and then allow cpu-port-mode else allow only user-port mode. Had not changed this, so currently only these 2
ports can be used as CPU.

> I suppose your patch does not bring support for using MT7530's port 5 as
> CPU port. We could try this on a BPI-R2. Device schematics show that
> MT7530's GMII pins are wired to GMAC1 of MT7623NI to work as RGMII.

my patches (and the version from Vladimir that was merged) only solves the Problem that CPU-Port was fixed to 6 before. I tested Patches on r2 
(mt7530) and r64 too (mt7531) that they do not break anything. But i have not disabled port 6 (maybe i had to do so for a port5-only mode), only
enabled port 5 too and run iperf3 over a vlan-aware bridge between wan-port and port 5.

> Arınç

regards Frank