[PATCH v2 1/5] arm64: dts: mediatek: Correct uart clock of MT8192

[allen-kh.cheng]

From: Allen-KH Cheng <Allen-KH.Cheng at mediatek.com>

When the initial devicetree for mt8192 was added in 48489980e27e ("arm64:
dts: Add Mediatek SoC MT8192 and evaluation board dts and Makefile"), the
clock driver for mt8192 was not yet upstream, so the clock property nodes
were set to the clk26m clock as a placeholder.

Given that the clock driver has since been added through 710573dee31b ("clk:
mediatek: Add MT8192 basic clocks support"), as well as its dt-bindings
through f35f1a23e0e1 ("clk: mediatek: Add dt-bindings of MT8192 clocks") and
devicetree nodes through 5d2b897bc6f5 ("arm64: dts: mediatek: Add mt8192
clock controllers"), fix the uart clock property to point to the actual

Signed-off-by: Allen-KH Cheng <Allen-KH.Cheng at mediatek.com>
---
 arch/arm64/boot/dts/mediatek/mt8192.dtsi | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/mediatek/mt8192.dtsi b/arch/arm64/boot/dts/mediatek/mt8192.dtsi
index c7c7d4e017ae..cfb67cc40c2c 100644
--- a/arch/arm64/boot/dts/mediatek/mt8192.dtsi
+++ b/arch/arm64/boot/dts/mediatek/mt8192.dtsi
@@ -327,7 +327,7 @@
 				     "mediatek,mt6577-uart";
 			reg = <0 0x11002000 0 0x1000>;
 			interrupts = <GIC_SPI 109 IRQ_TYPE_LEVEL_HIGH 0>;
-			clocks = <&clk26m>, <&clk26m>;
+			clocks = <&clk26m>, <&infracfg CLK_INFRA_UART0>;
 			clock-names = "baud", "bus";
 			status = "disabled";
 		};
@@ -337,7 +337,7 @@
 				     "mediatek,mt6577-uart";
 			reg = <0 0x11003000 0 0x1000>;
 			interrupts = <GIC_SPI 110 IRQ_TYPE_LEVEL_HIGH 0>;
-			clocks = <&clk26m>, <&clk26m>;
+			clocks = <&clk26m>, <&infracfg CLK_INFRA_UART1>;
 			clock-names = "baud", "bus";
 			status = "disabled";
 		};
-- 
2.18.0