[PATCH v8 05/19] drm/mediatek: dpi: move dpi limits to board config

Guillaume Ranquet granquet at baylibre.com
Fri Feb 18 06:54:23 PST 2022


Add flexibility by moving the dpi limits to the board config

Signed-off-by: Guillaume Ranquet <granquet at baylibre.com>
---
 drivers/gpu/drm/mediatek/mtk_dpi.c | 25 ++++++++++++++++---------
 1 file changed, 16 insertions(+), 9 deletions(-)

diff --git a/drivers/gpu/drm/mediatek/mtk_dpi.c b/drivers/gpu/drm/mediatek/mtk_dpi.c
index 4554e2de14309..4746eb3425674 100644
--- a/drivers/gpu/drm/mediatek/mtk_dpi.c
+++ b/drivers/gpu/drm/mediatek/mtk_dpi.c
@@ -125,6 +125,7 @@ struct mtk_dpi_conf {
 	bool edge_sel_en;
 	const u32 *output_fmts;
 	u32 num_output_fmts;
+	const struct mtk_dpi_yc_limit *limit;
 };
 
 static void mtk_dpi_mask(struct mtk_dpi *dpi, u32 offset, u32 val, u32 mask)
@@ -235,9 +236,10 @@ static void mtk_dpi_config_fb_size(struct mtk_dpi *dpi, u32 width, u32 height)
 	mtk_dpi_mask(dpi, DPI_SIZE, height << VSIZE, VSIZE_MASK);
 }
 
-static void mtk_dpi_config_channel_limit(struct mtk_dpi *dpi,
-					 struct mtk_dpi_yc_limit *limit)
+static void mtk_dpi_config_channel_limit(struct mtk_dpi *dpi)
 {
+	const struct mtk_dpi_yc_limit *limit = dpi->conf->limit;
+
 	mtk_dpi_mask(dpi, DPI_Y_LIMIT, limit->y_bottom << Y_LIMINT_BOT,
 		     Y_LIMINT_BOT_MASK);
 	mtk_dpi_mask(dpi, DPI_Y_LIMIT, limit->y_top << Y_LIMINT_TOP,
@@ -449,7 +451,6 @@ static int mtk_dpi_power_on(struct mtk_dpi *dpi)
 static int mtk_dpi_set_display_mode(struct mtk_dpi *dpi,
 				    struct drm_display_mode *mode)
 {
-	struct mtk_dpi_yc_limit limit;
 	struct mtk_dpi_polarities dpi_pol;
 	struct mtk_dpi_sync_param hsync;
 	struct mtk_dpi_sync_param vsync_lodd = { 0 };
@@ -484,11 +485,6 @@ static int mtk_dpi_set_display_mode(struct mtk_dpi *dpi,
 	dev_dbg(dpi->dev, "Got  PLL %lu Hz, pixel clock %lu Hz\n",
 		pll_rate, vm.pixelclock);
 
-	limit.c_bottom = 0x0010;
-	limit.c_top = 0x0FE0;
-	limit.y_bottom = 0x0010;
-	limit.y_top = 0x0FE0;
-
 	dpi_pol.ck_pol = MTK_DPI_POLARITY_FALLING;
 	dpi_pol.de_pol = MTK_DPI_POLARITY_RISING;
 	dpi_pol.hsync_pol = vm.flags & DISPLAY_FLAGS_HSYNC_HIGH ?
@@ -536,7 +532,7 @@ static int mtk_dpi_set_display_mode(struct mtk_dpi *dpi,
 	else
 		mtk_dpi_config_fb_size(dpi, vm.hactive, vm.vactive);
 
-	mtk_dpi_config_channel_limit(dpi, &limit);
+	mtk_dpi_config_channel_limit(dpi);
 	mtk_dpi_config_bit_num(dpi, dpi->bit_num);
 	mtk_dpi_config_channel_swap(dpi, dpi->channel_swap);
 	mtk_dpi_config_yc_map(dpi, dpi->yc_map);
@@ -790,12 +786,20 @@ static const u32 mt8183_output_fmts[] = {
 	MEDIA_BUS_FMT_RGB888_2X12_BE,
 };
 
+static const struct mtk_dpi_yc_limit mtk_dpi_limit = {
+	.c_bottom = 0x0010,
+	.c_top = 0x0FE0,
+	.y_bottom = 0x0010,
+	.y_top = 0x0FE0,
+};
+
 static const struct mtk_dpi_conf mt8173_conf = {
 	.cal_factor = mt8173_calculate_factor,
 	.reg_h_fre_con = 0xe0,
 	.max_clock_khz = 300000,
 	.output_fmts = mt8173_output_fmts,
 	.num_output_fmts = ARRAY_SIZE(mt8173_output_fmts),
+	.limit = &mtk_dpi_limit,
 };
 
 static const struct mtk_dpi_conf mt2701_conf = {
@@ -805,6 +809,7 @@ static const struct mtk_dpi_conf mt2701_conf = {
 	.max_clock_khz = 150000,
 	.output_fmts = mt8173_output_fmts,
 	.num_output_fmts = ARRAY_SIZE(mt8173_output_fmts),
+	.limit = &mtk_dpi_limit,
 };
 
 static const struct mtk_dpi_conf mt8183_conf = {
@@ -813,6 +818,7 @@ static const struct mtk_dpi_conf mt8183_conf = {
 	.max_clock_khz = 100000,
 	.output_fmts = mt8183_output_fmts,
 	.num_output_fmts = ARRAY_SIZE(mt8183_output_fmts),
+	.limit = &mtk_dpi_limit,
 };
 
 static const struct mtk_dpi_conf mt8192_conf = {
@@ -821,6 +827,7 @@ static const struct mtk_dpi_conf mt8192_conf = {
 	.max_clock_khz = 150000,
 	.output_fmts = mt8173_output_fmts,
 	.num_output_fmts = ARRAY_SIZE(mt8173_output_fmts),
+	.limit = &mtk_dpi_limit,
 };
 
 static int mtk_dpi_probe(struct platform_device *pdev)
-- 
2.34.1




More information about the Linux-mediatek mailing list