[PATCH v4 1/3] dt-bindings: mmc: add cap-sdio-async-irq flag

Ulf Hansson ulf.hansson at linaro.org
Mon Feb 14 07:23:10 PST 2022


On Wed, 19 Jan 2022 at 11:32, Axe Yang <axe.yang at mediatek.com> wrote:
>
> Asynchronous interrupt is a mechanism that allow SDIO devices alarm
> interrupt when host stop providing clock to card. Add a DT flag to
> enable this feature if it is supported by SDIO card.
>
> Signed-off-by: Axe Yang <axe.yang at mediatek.com>
> ---
>  Documentation/devicetree/bindings/mmc/mmc-controller.yaml | 5 +++++
>  1 file changed, 5 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/mmc/mmc-controller.yaml b/Documentation/devicetree/bindings/mmc/mmc-controller.yaml
> index 513f3c8758aa..16fb06f88471 100644
> --- a/Documentation/devicetree/bindings/mmc/mmc-controller.yaml
> +++ b/Documentation/devicetree/bindings/mmc/mmc-controller.yaml
> @@ -165,6 +165,11 @@ properties:
>      description:
>        eMMC hardware reset is supported
>
> +  cap-sdio-async-irq:
> +    $ref: /schemas/types.yaml#/definitions/flag
> +    description:
> +      SDIO async interrupt is supported.

We already have a DT property for this, I believe.

"wakeup-source" is probably what you want, but we have additional
properties that are related to this too. See more below.

> +
>    cap-sdio-irq:
>      $ref: /schemas/types.yaml#/definitions/flag
>      description:

The above, "cap-sdio-irq", informs whether the SDIO IRQs can be
supported at all, by the host controller.

The property "keep-power-in-suspend" informs whether we can preserve
the power to the card during a suspend/resume cycle. This should be
needed in your case too, I think.

In other words, you may need to combine "cap-sdio-irq",
"wakeup-source" and "keep-power-in-suspend" to describe your HW.

However, what perhaps is missing, is a common MMC/SDIO binding that
let us describe an optional irq-line, which sometimes is being used
for the wakeup irq. In the sdhci-omap case, we look for an irq mapping
towards "wakeup" if specified in the "interrupt-names" property.

In some case, when the SDIO card supports an out-of-band IRQ line, the
similar should be specified in the child-node corresponding to the
SDIO card.

Kind regards
Uffe



More information about the Linux-mediatek mailing list