[PATCH v25 0/7] Add MediaTek SoC DRM (vdosys1) support for mt8195
Nancy.Lin
nancy.lin at mediatek.com
Thu Aug 4 00:28:20 PDT 2022
The hardware path of vdosys1 with DPTx output need to go through by several modules, such as, OVL_ADAPTOR and MERGE.
Add DRM and these modules support by the patches below:
Changes in v25:
- rebase to next-20220803
Changes in v24:
- fix ovl_adaptor binding issue (mtk_disp_ovl_adaptor.c)
- Since ovl_adaptor is an aggregated component, it should be bounded after
all its child components are bounded.
- rebase to next-20220708
Changes in v23:
- separate[7] mmsys/mutex and drm patches into two series
Changes in v22:
- rebase to next-20220525
- rebase to vdosys0 series v22
- separate dts to a new patch
Changes in v21:
- fix reviewer comment
- fix rdma and ethdr binding doc and dts
Changes in v20:
- fix reviewer comment
- update mmsys update bit api name
- add mtk_mmsys_update_bits error message if lose gce property
- list all mt8195 vdosys1 reset bits
Changes in v19:
- fix reviewer comment
- separate mt8195 mmsys component to a new patch
- separate mt8195 vdo0 and vdo1 routing table
- separate mmsys_write_reg api to a new patch and simplify write reg code
- separate mmsys 64 bit reset to a new patch
- separate mtk-mutex dp_intf1 component to a new patch
Changes in v18:
- fix reviewer comment
- fix rdma binding doc
- fix ethdr binding doc
- refine mmsys config cmdq support
- refine merge reset control flow, get reset control in probe function
- add ethdr reset control error handling and remove dbg log
- rebase to vdosys0 series v20 (ref [5])
Changes in v17:
- fix reviewer comment in v16
- separate ovl adaptor comp in mtk-mmsys and mtk-mutex
- separate mmsys config API
- move mdp_rdma binding yaml
- fix ovl adaptor pm runtime get sync timing issue
- rebase to vdosys0 series v19 (ref [5])
- rebase to [7] for modify vblank register change
Changes in v16:
- fix reviewer comment in v 15
- fix mtk_drm_ddp_comp.c alignment
- fix vdosys0 mmsys num before adding vdosys1 patch
Changes in v15:
- fix ethdr uppercase hex number in dts
Changes in v14:
- remove MTK_MMSYS 64 bit dependency
- add ethdr.yaml back and fix dt_schema check fail
Resend v13
- add related maintainer in maillist
Changes in v13:
- fix reviewer comment in v12
- fix rdma dt-binding format
- fix dts node naming
- fix 32 bit build error
- modify 64bit dependency for mtk-mmsys
- rebase to vdosys0 series v16. (ref [5])
Changes in v12:
- fix reviewer comment in v11
- modify mbox index
- refine dma dev for ovl_adaptor sub driver
Changes in v11:
- remove ethdr vblank spin lock
- refine ovl_adaptor print message
Changes in v10:
- refine ethdr reset control using devm_reset_control_array_get_optional_exclusive
- fix ovl_adaptor mtk_ovl_adaptor_clk_enable error handle issue
Changes in v9:
- rebase on kernel-5.16-rc1
- rebase on vdosys0 series v13. (ref [5])
- fix ovl_adaptor sub driver is brought up unintentionally
- fix clang build test fail- duplicate ethdr/mdp_rdma init_module/cleanup_module symbol issue
Changes in v8:
- separate merge async reset to new patch.
- separate drm ovl_adaptor sub driver to new patch.
- fix reviewer comment in v7.
Changes in v7:
- rebase on vdosys0 series v12 (ref[5])
- add dma description in ethdr binding document.
- refine vdosys1 bit definition of mmsys routing table.
- separate merge modification into 3 pathces.
- separate mutex modification into 2 patches.
- add plane color coding for mdp_rdma csc.
- move mdp_rdma pm control to ovl_adaptor.
- fix reviewer comment in v6.
Changes in v6:
- rebase on kernel-5.15-rc1.
- change mbox label to gce0 for dts node of vdosys1.
- modify mmsys reset num for mt8195.
- rebase on vdosys0 series v10. (ref [5])
- use drm to bring up ovl_adaptor driver.
- move drm iommu/mutex check from kms init to drm bind.
- modify rdma binding doc location. (Documentation/devicetree/bindings/arm/)
- modify for reviewer's comment in v5.
Changes in v5:
- add mmsys reset controller reference.
Changes in v4:
- use merge common driver for merge1~4.
- refine ovl_adaptor rdma driver.
- use ovl_adaptor ddp_comp function instead of ethdr.
- modify for reviewer's comment in v3.
Changes in v3:
- modify for reviewer's comment in v2.
- add vdosys1 2 pixels align limit.
- add mixer odd offset support.
Changes in v2:
- Merge PSEUDO_OVL and ETHDR into one DRM component.
- Add mmsys config API for vdosys1 hardware setting.
- Add mmsys reset control using linux reset framework.
Signed-off-by: Nancy.Lin <nancy.lin at mediatek.com>
This series are based on the following patch:
[1] arm64: dts: Add mediatek SoC mt8195 and evaluation board
20220112114724.1953-4-tinghan.shen at mediatek.com
[2] arm64: dts: mt8195: add IOMMU and smi nodes
20210615173233.26682-15-tinghan.shen at mediatek.com
[3] [v2] arm64: dts: mt8195: add display node for vdosys0
20220225021535.2655-1-jason-jh.lin at mediatek.com
[4] dt-bindings: mediatek: mt8195: Add binding for MM IOMMU
20220407075726.17771-2-yong.wu at mediatek.com
[5] Add MediaTek SoC DRM (vdosys1) support for mt8195
20220526110233.20080-1-nancy.lin at mediatek.com
Nancy.Lin (7):
dt-bindings: mediatek: add ethdr definition for mt8195
drm/mediatek: add ETHDR support for MT8195
drm/mediatek: add ovl_adaptor support for MT8195
drm/mediatek: add dma dev get function
drm/mediatek: modify mediatek-drm for mt8195 multi mmsys support
drm/mediatek: add drm ovl_adaptor sub driver for MT8195
drm/mediatek: add mediatek-drm of vdosys1 support for MT8195
.../display/mediatek/mediatek,ethdr.yaml | 188 +++++++
drivers/gpu/drm/mediatek/Makefile | 2 +
drivers/gpu/drm/mediatek/mtk_disp_drv.h | 26 +
.../gpu/drm/mediatek/mtk_disp_ovl_adaptor.c | 528 ++++++++++++++++++
drivers/gpu/drm/mediatek/mtk_drm_crtc.c | 96 ++--
drivers/gpu/drm/mediatek/mtk_drm_crtc.h | 6 +-
drivers/gpu/drm/mediatek/mtk_drm_ddp_comp.c | 129 +++--
drivers/gpu/drm/mediatek/mtk_drm_ddp_comp.h | 58 +-
drivers/gpu/drm/mediatek/mtk_drm_drv.c | 359 ++++++++----
drivers/gpu/drm/mediatek/mtk_drm_drv.h | 24 +-
drivers/gpu/drm/mediatek/mtk_ethdr.c | 370 ++++++++++++
drivers/gpu/drm/mediatek/mtk_ethdr.h | 26 +
12 files changed, 1615 insertions(+), 197 deletions(-)
create mode 100644 Documentation/devicetree/bindings/display/mediatek/mediatek,ethdr.yaml
create mode 100644 drivers/gpu/drm/mediatek/mtk_disp_ovl_adaptor.c
create mode 100644 drivers/gpu/drm/mediatek/mtk_ethdr.c
create mode 100644 drivers/gpu/drm/mediatek/mtk_ethdr.h
--
2.18.0
More information about the Linux-mediatek
mailing list