[PATCH] dt-bindings: pinctrl: mt8192: Add mediatek, pull-down-adv property

[Krzysztof Kozlowski]

On 29/04/2022 22:06, Nícolas F. R. A. Prado wrote:
> Add the mediatek,pull-down-adv property to the pinctrl-mt8192 dt-binding
> to allow configuring pull-down resistors on the pins of MT8192. It is
> the same as in mt8183-pinctrl.
> 
> Signed-off-by: Nícolas F. R. A. Prado <nfraprado at collabora.com>
> 
> ---
> 
>  .../devicetree/bindings/pinctrl/pinctrl-mt8192.yaml   | 11 +++++++++++
>  1 file changed, 11 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-mt8192.yaml b/Documentation/devicetree/bindings/pinctrl/pinctrl-mt8192.yaml
> index c90a132fbc79..e462f49eae6f 100644
> --- a/Documentation/devicetree/bindings/pinctrl/pinctrl-mt8192.yaml
> +++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-mt8192.yaml
> @@ -117,6 +117,17 @@ patternProperties:
>              $ref: /schemas/types.yaml#/definitions/uint32
>              enum: [0, 1, 2, 3]
>  
> +          mediatek,pull-down-adv:
> +            description: |
> +              Pull down settings for 2 pull resistors, R0 and R1. User can
> +              configure those special pins. Valid arguments are described as below:

Trailing ':' should be escaped, so '::'


> +              0: (R1, R0) = (0, 0) which means R1 disabled and R0 disabled.
> +              1: (R1, R0) = (0, 1) which means R1 disabled and R0 enabled.
> +              2: (R1, R0) = (1, 0) which means R1 enabled and R0 disabled.
> +              3: (R1, R0) = (1, 1) which means R1 enabled and R0 enabled.
> +            $ref: /schemas/types.yaml#/definitions/uint32
> +            enum: [0, 1, 2, 3]

It's okay, but for all these and other values (you have few such in the
binding), you should maybe add header and defines. It's much more
readable for humans...

Is the property valid without bias-pull-down?

Best regards,
Krzysztof