[PATCH V2 02/12] clk: mediatek: reset: Use simple reset operations

[Chen-Yu Tsai]

On Wed, Apr 20, 2022 at 9:05 PM Rex-BC Chen <rex-bc.chen at mediatek.com> wrote:
>
> There are two version for clock reset register control of MediaTek SoCs.
> The reset operations before MT8183 can use simple reset to cover.

I would go slightly into more detail, i.e.

    The old hardware is one bit per reset control, and does not have
    separate registers for bit set, clear and read-back operations. This
    matches the scheme supported by the simple reset driver. ...

> Therefore, we replace mtk_reset_ops with reset_simple_ops.

   ... to remove redundant code.

The "why" is more important than "what" in commit logs. "What" you did
is already visible in the diff.

> In addition, we also rename mtk_register_reset_controller to
> mtk_register_reset_controller_simple.
>
> Signed-off-by: Rex-BC Chen <rex-bc.chen at mediatek.com>
> ---
>  drivers/clk/mediatek/Kconfig          |  1 +
>  drivers/clk/mediatek/clk-mt2701-eth.c |  2 +-
>  drivers/clk/mediatek/clk-mt2701-g3d.c |  2 +-
>  drivers/clk/mediatek/clk-mt2701-hif.c |  2 +-
>  drivers/clk/mediatek/clk-mt2701.c     |  4 +--
>  drivers/clk/mediatek/clk-mt2712.c     |  4 +--
>  drivers/clk/mediatek/clk-mt7622-eth.c |  2 +-
>  drivers/clk/mediatek/clk-mt7622-hif.c |  4 +--
>  drivers/clk/mediatek/clk-mt7622.c     |  4 +--
>  drivers/clk/mediatek/clk-mt7629-eth.c |  2 +-
>  drivers/clk/mediatek/clk-mt7629-hif.c |  4 +--
>  drivers/clk/mediatek/clk-mt8135.c     |  4 +--
>  drivers/clk/mediatek/clk-mt8173.c     |  4 +--
>  drivers/clk/mediatek/clk-mtk.h        |  6 ++--
>  drivers/clk/mediatek/reset.c          | 43 +++------------------------
>  15 files changed, 27 insertions(+), 61 deletions(-)

[...]

>  void mtk_register_reset_controller_set_clr(struct device_node *np,
>         unsigned int num_regs, int regofs)
>  {
>         mtk_register_reset_controller_common(np, num_regs, regofs,
> -               &mtk_reset_ops_set_clr);
> +                                            &mtk_reset_ops_set_clr);

This change is unrelated and should not be included.

ChenYu


>  }
>
>  MODULE_LICENSE("GPL");
> --
> 2.18.0
>