[PATCH 1/7] clk: mediatek: reset: Correct the logic of setting register

[Rex-BC Chen]

Original assert/deassert bit is BIT(0), but it's more resonable to modify
them to BIT(id % 32) which is based on id.

This patch will not influence any previous driver because the reset is
only used for thermal. The id (MT8183_INFRACFG_AO_THERM_SW_RST) is 0.

Fixes: 64ebb57a3df6 ("clk: reset: Modify reset-controller driver")
Signed-off-by: Rex-BC Chen <rex-bc.chen at mediatek.com>
---
 drivers/clk/mediatek/reset.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/clk/mediatek/reset.c b/drivers/clk/mediatek/reset.c
index bcec4b89f449..834d26e9bdfd 100644
--- a/drivers/clk/mediatek/reset.c
+++ b/drivers/clk/mediatek/reset.c
@@ -25,7 +25,7 @@ static int mtk_reset_assert_set_clr(struct reset_controller_dev *rcdev,
 	struct mtk_reset *data = container_of(rcdev, struct mtk_reset, rcdev);
 	unsigned int reg = data->regofs + ((id / 32) << 4);
 
-	return regmap_write(data->regmap, reg, 1);
+	return regmap_write(data->regmap, reg, BIT(id % 32));
 }
 
 static int mtk_reset_deassert_set_clr(struct reset_controller_dev *rcdev,
@@ -34,7 +34,7 @@ static int mtk_reset_deassert_set_clr(struct reset_controller_dev *rcdev,
 	struct mtk_reset *data = container_of(rcdev, struct mtk_reset, rcdev);
 	unsigned int reg = data->regofs + ((id / 32) << 4) + 0x4;
 
-	return regmap_write(data->regmap, reg, 1);
+	return regmap_write(data->regmap, reg, BIT(id % 32));
 }
 
 static int mtk_reset_assert(struct reset_controller_dev *rcdev,
-- 
2.18.0