[PATCH v1 6/6] drm/mediatek: Add mt8195 DisplayPort driver

Markus Schneider-Pargmann msp at baylibre.com
Thu Sep 9 05:45:30 PDT 2021


Hi Sam,

On Mon, Sep 06, 2021 at 10:39:21PM +0200, Sam Ravnborg wrote:
> Hi Markus,
> 
> On Mon, Sep 06, 2021 at 09:35:29PM +0200, Markus Schneider-Pargmann wrote:
> > This patch adds a DisplayPort driver for the Mediatek mt8195 SoC.
> > 
> > It supports both functional units on the mt8195, the embedded
> > DisplayPort as well as the external DisplayPort units. It offers
> > hot-plug-detection, audio up to 8 channels, and DisplayPort 1.4 with up
> > to 4 lanes.
> > 
> > This driver is based on an initial version by
> > Jason-JH.Lin <jason-jh.lin at mediatek.com>.
> > 
> > Signed-off-by: Markus Schneider-Pargmann <msp at baylibre.com>
> > ---
> > 
> > Notes:
> >     Changes RFC -> v1:
> >     - Removed unused register definitions.
> >     - Replaced workqueue with threaded irq.
> >     - Removed connector code.
> >     - Move to atomic_* drm functions.
> >     - General cleanups of the code.
> >     - Remove unused select GENERIC_PHY.
> > 
> >  drivers/gpu/drm/mediatek/Kconfig      |    6 +
> >  drivers/gpu/drm/mediatek/Makefile     |    2 +
> >  drivers/gpu/drm/mediatek/mtk_dp.c     | 2881 +++++++++++++++++++++++++
> >  drivers/gpu/drm/mediatek/mtk_dp_reg.h |  580 +++++
> >  4 files changed, 3469 insertions(+)
> >  create mode 100644 drivers/gpu/drm/mediatek/mtk_dp.c
> >  create mode 100644 drivers/gpu/drm/mediatek/mtk_dp_reg.h
> > 
> 
> 
> > +
> > +static const struct drm_bridge_funcs mtk_dp_bridge_funcs = {
> > +	.atomic_duplicate_state = drm_atomic_helper_bridge_duplicate_state,
> > +	.atomic_destroy_state = drm_atomic_helper_bridge_destroy_state,
> > +	.atomic_reset = drm_atomic_helper_bridge_reset,
> > +	.attach = mtk_dp_bridge_attach,
> > +	.detach = mtk_dp_bridge_detach,
> > +	.pre_enable = mtk_dp_bridge_pre_enable,
> Use the atomic variant here as pre_enable is deprecated.
> 
> > +	.atomic_enable = mtk_dp_bridge_atomic_enable,
> > +	.atomic_disable = mtk_dp_bridge_atomic_disable,
> > +	.post_disable = mtk_dp_bridge_post_disable,
> Use the atomic variant here as .post_disable is deprecated.

Thanks, I got rid of both pre_enable and post_disable as well now.

> 
> > +	.get_edid = mtk_dp_get_edid,
> > +	.detect = mtk_dp_bdg_detect,
> > +};
> 
> Everything else I skimmed looked fine. But it was a quick skim so..

Thanks for taking the time to have a look.

Best,
Markus



More information about the Linux-mediatek mailing list