[PATCH v2] irqchip/irq-mst: Support polarity configuration

[Daniel Palmer]

On Fri, 12 Mar 2021 at 01:11, Mark-PK Tsai <mark-pk.tsai at mediatek.com> wrote:
> Why irq could accept either?

As the irq intc has no way to clear it's triggered state (no eoi) it
must just pass the signal through instead of latching it?
Otherwise it would latch once and never again right? That's what I
really didn't understand.
If it just passes the signal through and maybe inverts it then the GIC
can use edge or level I think.

> So maybe we don't need to do extra work to check the type for an fiq or irq controller?

I think without the eoi callback for the fiq it would only ever fire
once. I don't think doing the same eoi callback for the irq intc hurts
anything but it wouldn't do anything either from what I can tell.

> And I will update the patch as following:

I think maybe Marc or someone else that knows better than I do should
comment on what needs to happen.
My input is just that the fiq controller seems to trigger on an edge,
holds it's signal to the GIC high until eoi happens and then only
triggers again on an edge.
I guess it doesn't matter if it's an edge or level if that's how it
works but you'd only get one interrupt out of it per edge even if
configured as a level interrupt.

The main thing I didn't want was filtering out edge interrupts
entirely as that breaks using edge interrupts with gpios i.e. using
gpiomon.
With the changes to set the polarity it can now detect rising or
falling edge gpio events. :)

Thanks,

Daniel