[PATCH v2] arm64: dts: mt8183-kukui: Enable thermal Tboard

[Matthias Brugger]

On 03/06/2021 12:59, Ben Tseng wrote:
> From: Michael Kao <michael.kao at mediatek.com>
> 
> Add Tboard thermal sensor settings.
> 
> pull-up voltage: 1800 mv
> pull-up resistor: 75K
> 
> Vsense = pull-up voltage * Rntc / ( pull-up resistor + Rntc )
> AuxIn = Vsense * 4096 / 1500
> 
> Signed-off-by: Michael Kao <michael.kao at mediatek.com>
> Signed-off-by: Ben Tseng <ben.tseng at mediatek.com>
> Tested-by: Hsin-Yi Wang <hsinyi at chromium.org>
> ---
> Change in v2:
>         - Rebase to kernel-v5.13-rc1
>         - Resend
> ---
>  arch/arm64/boot/dts/mediatek/mt8183-kukui.dtsi | 14 ++++++++++++++
>  arch/arm64/boot/dts/mediatek/mt8183.dtsi       |  2 +-
>  2 files changed, 15 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/arm64/boot/dts/mediatek/mt8183-kukui.dtsi b/arch/arm64/boot/dts/mediatek/mt8183-kukui.dtsi
> index ff56bcf..65768ab 100644
> --- a/arch/arm64/boot/dts/mediatek/mt8183-kukui.dtsi
> +++ b/arch/arm64/boot/dts/mediatek/mt8183-kukui.dtsi
> @@ -847,6 +847,20 @@
>  	status = "okay";
>  };
>  
> +&thermal_zones {
> +	Tboard1 {

Lower-case please. It would be also good to know what tboard1 and 2 stands for.

Regards,
Matthias

> +		polling-delay = <1000>; /* milliseconds */
> +		polling-delay-passive = <0>; /* milliseconds */
> +		thermal-sensors = <&tboard_thermistor1>;
> +	};
> +
> +	Tboard2 {
> +		polling-delay = <1000>; /* milliseconds */
> +		polling-delay-passive = <0>; /* milliseconds */
> +		thermal-sensors = <&tboard_thermistor2>;
> +	};
> +};
> +
>  &u3phy {
>  	status = "okay";
>  };
> diff --git a/arch/arm64/boot/dts/mediatek/mt8183.dtsi b/arch/arm64/boot/dts/mediatek/mt8183.dtsi
> index c5e822b..4173a5d 100644
> --- a/arch/arm64/boot/dts/mediatek/mt8183.dtsi
> +++ b/arch/arm64/boot/dts/mediatek/mt8183.dtsi
> @@ -673,7 +673,7 @@
>  			nvmem-cell-names = "calibration-data";
>  		};
>  
> -		thermal-zones {
> +		thermal_zones: thermal-zones {
>  			cpu_thermal: cpu_thermal {
>  				polling-delay-passive = <100>;
>  				polling-delay = <500>;
>