[PATCH net-next v10 2/6] stmmac: dwmac-mediatek: Reuse more common features

Biao Huang biao.huang at mediatek.com
Wed Dec 15 21:53:24 PST 2021


This patch makes dwmac-mediatek reuse more features
supported by stmmac_platform.c.

Signed-off-by: Biao Huang <biao.huang at mediatek.com>
Acked-by: AngeloGioacchino Del Regno <angelogioacchino.delregno at collabora.com>
---
 .../ethernet/stmicro/stmmac/dwmac-mediatek.c  | 32 +++++++++----------
 1 file changed, 15 insertions(+), 17 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-mediatek.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-mediatek.c
index 0ff57c268dca..8747aa4403e8 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-mediatek.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-mediatek.c
@@ -334,22 +334,20 @@ static int mediatek_dwmac_init(struct platform_device *pdev, void *priv)
 	const struct mediatek_dwmac_variant *variant = plat->variant;
 	int ret;
 
-	ret = dma_set_mask_and_coherent(plat->dev, DMA_BIT_MASK(variant->dma_bit_mask));
-	if (ret) {
-		dev_err(plat->dev, "No suitable DMA available, err = %d\n", ret);
-		return ret;
-	}
-
-	ret = variant->dwmac_set_phy_interface(plat);
-	if (ret) {
-		dev_err(plat->dev, "failed to set phy interface, err = %d\n", ret);
-		return ret;
+	if (variant->dwmac_set_phy_interface) {
+		ret = variant->dwmac_set_phy_interface(plat);
+		if (ret) {
+			dev_err(plat->dev, "failed to set phy interface, err = %d\n", ret);
+			return ret;
+		}
 	}
 
-	ret = variant->dwmac_set_delay(plat);
-	if (ret) {
-		dev_err(plat->dev, "failed to set delay value, err = %d\n", ret);
-		return ret;
+	if (variant->dwmac_set_delay) {
+		ret = variant->dwmac_set_delay(plat);
+		if (ret) {
+			dev_err(plat->dev, "failed to set delay value, err = %d\n", ret);
+			return ret;
+		}
 	}
 
 	ret = clk_bulk_prepare_enable(plat->num_clks_to_config, plat->clks);
@@ -422,15 +420,15 @@ static int mediatek_dwmac_probe(struct platform_device *pdev)
 		return PTR_ERR(plat_dat);
 
 	plat_dat->interface = priv_plat->phy_mode;
-	plat_dat->has_gmac4 = 1;
-	plat_dat->has_gmac = 0;
-	plat_dat->pmt = 0;
+	plat_dat->use_phy_wol = 1;
 	plat_dat->riwt_off = 1;
 	plat_dat->maxmtu = ETH_DATA_LEN;
+	plat_dat->addr64 = priv_plat->variant->dma_bit_mask;
 	plat_dat->bsp_priv = priv_plat;
 	plat_dat->init = mediatek_dwmac_init;
 	plat_dat->exit = mediatek_dwmac_exit;
 	plat_dat->clks_config = mediatek_dwmac_clks_config;
+
 	mediatek_dwmac_init(pdev, priv_plat);
 
 	ret = stmmac_dvr_probe(&pdev->dev, plat_dat, &stmmac_res);
-- 
2.25.1




More information about the Linux-mediatek mailing list