[RFC net-next v2 3/4] net: dsa: mt7530: set STP state also on filter ID 1

DENG Qingfang dqfext at gmail.com
Mon Aug 2 08:58:10 PDT 2021


On Mon, Aug 02, 2021 at 06:42:26PM +0300, Vladimir Oltean wrote:
> On Mon, Aug 02, 2021 at 11:31:29PM +0800, DENG Qingfang wrote:
> > The current code only sets FID 0's STP state. This patch sets both 0's and
> > 1's states.
> >
> > The *5 part is binary magic. [1:0] is FID 0's state, [3:2] is FID 1's state
> > and so on. Since 5 == 4'b0101, the value in [1:0] is copied to [3:2] after
> > the multiplication.
> >
> > Perhaps I should only change FID 1's state.
> 
> Keep the patches dumb for us mortals please.
> If you only change FID 1's state, I am concerned that the driver no
> longer initializes FID 0's port state, and might leave that to the
> default set by other pre-kernel initialization stage (bootloader?).
> So even if you might assume that standalone ports are FORWARDING, they
> might not be.

The default value is forwarding, and the switch is reset by the driver
so any pre-kernel initialization stage is no more.



More information about the Linux-mediatek mailing list