[PATCH v3 07/15] arm64: dts: xilinx: align GPIO hog names with dtschema

[Michal Simek]

On 16. 09. 20 17:57, Krzysztof Kozlowski wrote:
> The convention for node names is to use hyphens, not underscores.
> dtschema for pca95xx expects GPIO hogs to end with 'hog' prefix.
> 
> Signed-off-by: Krzysztof Kozlowski <krzk at kernel.org>
> ---
>  arch/arm64/boot/dts/xilinx/zynqmp-zcu102-revA.dts | 8 ++++----
>  1 file changed, 4 insertions(+), 4 deletions(-)
> 
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu102-revA.dts b/arch/arm64/boot/dts/xilinx/zynqmp-zcu102-revA.dts
> index 4f801721564f..f1255f635dfd 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu102-revA.dts
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu102-revA.dts
> @@ -203,25 +203,25 @@
>  		gpio-line-names = "PS_GTR_LAN_SEL0", "PS_GTR_LAN_SEL1", "PS_GTR_LAN_SEL2", "PS_GTR_LAN_SEL3",
>  				"PCI_CLK_DIR_SEL", "IIC_MUX_RESET_B", "GEM3_EXP_RESET_B",
>  				"", "", "", "", "", "", "", "", "";
> -		gtr-sel0 {
> +		gtr-sel0-hog {
>  			gpio-hog;
>  			gpios = <0 0>;
>  			output-low; /* PCIE = 0, DP = 1 */
>  			line-name = "sel0";
>  		};
> -		gtr-sel1 {
> +		gtr-sel1-hog {
>  			gpio-hog;
>  			gpios = <1 0>;
>  			output-high; /* PCIE = 0, DP = 1 */
>  			line-name = "sel1";
>  		};
> -		gtr-sel2 {
> +		gtr-sel2-hog {
>  			gpio-hog;
>  			gpios = <2 0>;
>  			output-high; /* PCIE = 0, USB0 = 1 */
>  			line-name = "sel2";
>  		};
> -		gtr-sel3 {
> +		gtr-sel3-hog {
>  			gpio-hog;
>  			gpios = <3 0>;
>  			output-high; /* PCIE = 0, SATA = 1 */
> 

Tony picked up some patches from this series that's why applied this one
to my tree.

Thanks,
Michal

-- 
Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel - Xilinx Microblaze
Maintainer of Linux kernel - Xilinx Zynq ARM and ZynqMP ARM64 SoCs
U-Boot custodian - Xilinx Microblaze/Zynq/ZynqMP/Versal SoCs