[PATCH] usb: musb: remove unused variable 'devctl'

Alan Stern stern at rowland.harvard.edu
Fri Nov 20 11:15:19 EST 2020


On Fri, Nov 20, 2020 at 09:36:33AM +0100, Greg Kroah-Hartman wrote:
> On Fri, Nov 20, 2020 at 03:42:06PM +0800, Min Guo wrote:
> > On Fri, 2020-11-20 at 07:54 +0100, Greg Kroah-Hartman wrote:
> > > On Fri, Nov 20, 2020 at 02:48:50PM +0800, Min Guo wrote:
> > > > Hi greg k-h:
> > > > On Wed, 2020-11-18 at 12:48 +0100, Greg Kroah-Hartman wrote:
> > > > > On Tue, Nov 17, 2020 at 04:21:25PM +0800, min.guo at mediatek.com wrote:
> > > > > > From: Min Guo <min.guo at mediatek.com>
> > > > > > 
> > > > > > Remove unused 'devctl' variable to fix compile warnings:
> > > > > > 
> > > > > >     drivers/usb/musb/musbhsdma.c: In function 'dma_controller_irq':
> > > > > >     drivers/usb/musb/musbhsdma.c:324:8: warning: variable 'devctl' set
> > > > > >     but not used [-Wunused-but-set-variable]
> > > > > > 
> > > > > > Signed-off-by: Min Guo <min.guo at mediatek.com>
> > > > > > ---
> > > > > >  drivers/usb/musb/musbhsdma.c | 4 ----
> > > > > >  1 file changed, 4 deletions(-)
> > > > > > 
> > > > > > diff --git a/drivers/usb/musb/musbhsdma.c b/drivers/usb/musb/musbhsdma.c
> > > > > > index 0aacfc8be5a1..7acd1635850d 100644
> > > > > > --- a/drivers/usb/musb/musbhsdma.c
> > > > > > +++ b/drivers/usb/musb/musbhsdma.c
> > > > > > @@ -321,8 +321,6 @@ irqreturn_t dma_controller_irq(int irq, void *private_data)
> > > > > >  				musb_channel->channel.status =
> > > > > >  					MUSB_DMA_STATUS_BUS_ABORT;
> > > > > >  			} else {
> > > > > > -				u8 devctl;
> > > > > > -
> > > > > >  				addr = musb_read_hsdma_addr(mbase,
> > > > > >  						bchannel);
> > > > > >  				channel->actual_len = addr
> > > > > > @@ -336,8 +334,6 @@ irqreturn_t dma_controller_irq(int irq, void *private_data)
> > > > > >  						< musb_channel->len) ?
> > > > > >  					"=> reconfig 0" : "=> complete");
> > > > > >  
> > > > > > -				devctl = musb_readb(mbase, MUSB_DEVCTL);
> > > > > 
> > > > > Are you sure that the hardware does not require this read to complete
> > > > > the command?  Lots of hardware is that way, so be very careful about
> > > > > this.  Did you test it?
> > > > 
> > > > I have tested this patch on Mediatek's platform, and not sure if it
> > > > will affect other vendors' platforms.
> > > > 
> > > > Dear Bin:
> > > > 
> > > > Does this patch will affect other vendors' platforms?
> > > 
> > > The hardware specs will answer this question, what do they say about
> > > this read?
> > 
> > Sorry, I didn't seen the comment on the hardware specs indicate that
> > devctl register needs to read once to take effect.
> 
> Perhaps you might want to add a comment here so that people will not
> keep making this same mistake when they run auto-checkers on the
> codebase?

A better change would be

-			devctl = musb_readb(mbase, MUSB_DEVCTL);
+			(void) musb_readb(mbase, MUSB_DEVCTL);

and eliminate the unused variable.  Then there wouldn't be any compiler 
warning.

Alan Stern



More information about the Linux-mediatek mailing list