[PATCH] pinctrl: fix low level output voltage issue

Zhiyong Tao zhiyong.tao at mediatek.com
Fri Nov 20 04:30:58 EST 2020


This patch is used to fix low level output voltage issue.
A pin is changed from input pull-up to output high.
The Dout value of the pin is default as 0.
If we change the direction of the pin before the dout value of the pin,
It maybe produce a low level output voltage between "input pull-up" and
"output high".

Signed-off-by: Zhiyong Tao <zhiyong.tao at mediatek.com>
---
 drivers/pinctrl/mediatek/pinctrl-paris.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/pinctrl/mediatek/pinctrl-paris.c b/drivers/pinctrl/mediatek/pinctrl-paris.c
index 623af4410b07..039ce9be19c5 100644
--- a/drivers/pinctrl/mediatek/pinctrl-paris.c
+++ b/drivers/pinctrl/mediatek/pinctrl-paris.c
@@ -247,13 +247,13 @@ static int mtk_pinconf_set(struct pinctrl_dev *pctldev, unsigned int pin,
 		err = mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_SR, !!arg);
 		break;
 	case PIN_CONFIG_OUTPUT:
-		err = mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_DIR,
-				       MTK_OUTPUT);
+		err = mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_DO,
+				       arg);
 		if (err)
 			goto err;
 
-		err = mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_DO,
-				       arg);
+		err = mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_DIR,
+				       MTK_OUTPUT);
 		break;
 	case PIN_CONFIG_INPUT_SCHMITT:
 	case PIN_CONFIG_INPUT_SCHMITT_ENABLE:
-- 
2.18.0


More information about the Linux-mediatek mailing list