[PATCH v1 9/9] scsi: ufs-qcom: Use common ADAPT configuration function

[Stanley Chu]

Use common ADAPT configuration function to reduce duplicated
code in UFS drivers.

Signed-off-by: Stanley Chu <stanley.chu at mediatek.com>
---
 drivers/scsi/ufs/ufs-qcom.c | 14 +++-----------
 1 file changed, 3 insertions(+), 11 deletions(-)

diff --git a/drivers/scsi/ufs/ufs-qcom.c b/drivers/scsi/ufs/ufs-qcom.c
index 04adfbd10753..1e434cce0f79 100644
--- a/drivers/scsi/ufs/ufs-qcom.c
+++ b/drivers/scsi/ufs/ufs-qcom.c
@@ -723,17 +723,9 @@ static int ufs_qcom_pwr_change_notify(struct ufs_hba *hba,
 			ufs_qcom_dev_ref_clk_ctrl(host, true);
 
 		if (host->hw_ver.major >= 0x4) {
-			if (dev_req_params->gear_tx == UFS_HS_G4) {
-				/* INITIAL ADAPT */
-				ufshcd_dme_set(hba,
-					       UIC_ARG_MIB(PA_TXHSADAPTTYPE),
-					       PA_INITIAL_ADAPT);
-			} else {
-				/* NO ADAPT */
-				ufshcd_dme_set(hba,
-					       UIC_ARG_MIB(PA_TXHSADAPTTYPE),
-					       PA_NO_ADAPT);
-			}
+			ufshcd_dme_configure_adapt(hba,
+						dev_req_params->gear_tx,
+						PA_INITIAL_ADAPT);
 		}
 		break;
 	case POST_CHANGE:
-- 
2.18.0