[PATCH RFC v1 1/1] scsi: pm: Leave runtime resume along if block layer PM is enabled
Can Guo
cang at codeaurora.org
Sun Nov 15 20:19:49 EST 2020
Hi Bart,
On 2020-11-15 04:57, Bart Van Assche wrote:
> On 11/12/20 10:30 PM, Can Guo wrote:
>> If block layer runtime PM is enabled for one SCSI device, then there
>> is
>> no need to forcibly change the SCSI device and its request queue's
>> runtime
>> PM status to active in scsi_dev_type_resume(), since block layer PM
>> shall
>> resume the SCSI device on the demand of bios.
>
> Please change "along" into "alone" in the subject of this patch (if
> that
> is what you meant).
>
Aha, sorry, a typo here.
>> + if (scsi_is_sdev_device(dev)) {
>> + struct scsi_device *sdev;
>>
>> + sdev = to_scsi_device(dev);
>
> A minor comment: I think that "struct scsi_device *sdev =
> to_scsi_device(dev);" fits on a single line.
>
Sure.
>> + * If block layer runtime PM is enabled for the SCSI device,
>> + * let block layer PM handle its runtime PM routines.
>
> Please change "its runtime PM routines" into "runtime resume" or
> similar. I think that will make the comment more clear.
>
Yes, thanks.
>> + if (sdev->request_queue->dev)
>> + return err;
>> + }
>
> The 'dev' member only exists in struct request_queue if CONFIG_PM=y so
> the above won't compile if CONFIG_PM=n. How about adding a function in
> include/linux/blk-pm.h to check whether or not runtime PM has been
> enabled?
>
You are right.
> Otherwise this patch looks good to me.
Actually, I am thinking about removing all the pm_runtime_set_active()
codes in both scsi_bus_resume_common() and scsi_dev_type_resume() - we
don't need to forcibly set the runtime PM status to RPM_ACTIVE for
either
SCSI host/target or SCSI devices.
Whenever we access one SCSI device, either block layer or somewhere in
the path (e.g. throgh sg IOCTL, sg_open() calls
scsi_autopm_get_device())
should runtime resume the device first, and the runtime PM framework
makes
sure device's gets resumed as well. Thus, the pm_runtime_set_active()
seems
redundant. What do you think?
Thanks,
Can Guo.
>
> Thanks,
>
> Bart.
More information about the Linux-mediatek
mailing list