[PATCH v6 06/10] iommu/mediatek: Add sub_comm id in translation fault

[Chao Hao]

The max larb number that a iommu HW support is 8(larb0~larb7 in the below
diagram).
If the larb's number is over 8, we use a sub_common for merging
several larbs into one larb. At this case, we will extend larb_id:
bit[11:9] means common-id;
bit[8:7] means subcommon-id;
From these two variables, we could get the real larb number when
translation fault happen.
The diagram is as below:
		 EMI
		  |
		IOMMU
		  |
           -----------------
	   |               |
	common1   	common0
	   |		   |
	   -----------------
		  |
             smi common
		  |
  ------------------------------------
  |       |       |       |     |    |
 3'd0    3'd1    3'd2    3'd3  ...  3'd7   <-common_id(max is 8)
  |       |       |       |     |    |
Larb0   Larb1     |     Larb3  ... Larb7
		  |
	    smi sub common
		  |
     --------------------------
     |        |       |       |
    2'd0     2'd1    2'd2    2'd3   <-sub_common_id(max is 4)
     |        |       |       |
   Larb8    Larb9   Larb10  Larb11

In this patch we extend larb_remap[] to larb_remap[8][4] for this.
larb_remap[x][y]: x means common-id above, y means subcommon_id above.

We can also distinguish if the M4U HW has sub_common by HAS_SUB_COMM
macro.

Cc: Matthias Brugger <matthias.bgg at gmail.com>
Signed-off-by: Chao Hao <chao.hao at mediatek.com>
Reviewed-by: Yong Wu <yong.wu at mediatek.com>
---
 drivers/iommu/mtk_iommu.c | 21 ++++++++++++++-------
 drivers/iommu/mtk_iommu.h |  5 ++++-
 2 files changed, 18 insertions(+), 8 deletions(-)

diff --git a/drivers/iommu/mtk_iommu.c b/drivers/iommu/mtk_iommu.c
index 533b8f76f592..0d96dcd8612b 100644
--- a/drivers/iommu/mtk_iommu.c
+++ b/drivers/iommu/mtk_iommu.c
@@ -91,6 +91,8 @@
 #define REG_MMU1_INVLD_PA			0x148
 #define REG_MMU0_INT_ID				0x150
 #define REG_MMU1_INT_ID				0x154
+#define F_MMU_INT_ID_COMM_ID(a)			(((a) >> 9) & 0x7)
+#define F_MMU_INT_ID_SUB_COMM_ID(a)		(((a) >> 7) & 0x3)
 #define F_MMU_INT_ID_LARB_ID(a)			(((a) >> 7) & 0x7)
 #define F_MMU_INT_ID_PORT_ID(a)			(((a) >> 2) & 0x1f)
 
@@ -109,6 +111,7 @@
 #define HAS_VLD_PA_RNG			BIT(2)
 #define RESET_AXI			BIT(3)
 #define OUT_ORDER_WR_EN			BIT(4)
+#define HAS_SUB_COMM			BIT(5)
 
 #define MTK_IOMMU_HAS_FLAG(pdata, _x) \
 		((((pdata)->flags) & (_x)) == (_x))
@@ -239,7 +242,7 @@ static irqreturn_t mtk_iommu_isr(int irq, void *dev_id)
 	struct mtk_iommu_data *data = dev_id;
 	struct mtk_iommu_domain *dom = data->m4u_dom;
 	u32 int_state, regval, fault_iova, fault_pa;
-	unsigned int fault_larb, fault_port;
+	unsigned int fault_larb, fault_port, sub_comm = 0;
 	bool layer, write;
 
 	/* Read error info from registers */
@@ -255,10 +258,14 @@ static irqreturn_t mtk_iommu_isr(int irq, void *dev_id)
 	}
 	layer = fault_iova & F_MMU_FAULT_VA_LAYER_BIT;
 	write = fault_iova & F_MMU_FAULT_VA_WRITE_BIT;
-	fault_larb = F_MMU_INT_ID_LARB_ID(regval);
 	fault_port = F_MMU_INT_ID_PORT_ID(regval);
-
-	fault_larb = data->plat_data->larbid_remap[fault_larb];
+	if (MTK_IOMMU_HAS_FLAG(data->plat_data, HAS_SUB_COMM)) {
+		fault_larb = F_MMU_INT_ID_COMM_ID(regval);
+		sub_comm = F_MMU_INT_ID_SUB_COMM_ID(regval);
+	} else {
+		fault_larb = F_MMU_INT_ID_LARB_ID(regval);
+	}
+	fault_larb = data->plat_data->larbid_remap[fault_larb][sub_comm];
 
 	if (report_iommu_fault(&dom->domain, data->dev, fault_iova,
 			       write ? IOMMU_FAULT_WRITE : IOMMU_FAULT_READ)) {
@@ -785,21 +792,21 @@ static const struct mtk_iommu_plat_data mt2712_data = {
 	.m4u_plat     = M4U_MT2712,
 	.flags        = HAS_4GB_MODE | HAS_BCLK | HAS_VLD_PA_RNG,
 	.inv_sel_reg  = REG_MMU_INV_SEL_GEN1,
-	.larbid_remap = {0, 1, 2, 3, 4, 5, 6, 7, 8, 9},
+	.larbid_remap = {{0}, {1}, {2}, {3}, {4}, {5}, {6}, {7}},
 };
 
 static const struct mtk_iommu_plat_data mt8173_data = {
 	.m4u_plat     = M4U_MT8173,
 	.flags	      = HAS_4GB_MODE | HAS_BCLK | RESET_AXI,
 	.inv_sel_reg  = REG_MMU_INV_SEL_GEN1,
-	.larbid_remap = {0, 1, 2, 3, 4, 5}, /* Linear mapping. */
+	.larbid_remap = {{0}, {1}, {2}, {3}, {4}, {5}}, /* Linear mapping. */
 };
 
 static const struct mtk_iommu_plat_data mt8183_data = {
 	.m4u_plat     = M4U_MT8183,
 	.flags        = RESET_AXI,
 	.inv_sel_reg  = REG_MMU_INV_SEL_GEN1,
-	.larbid_remap = {0, 4, 5, 6, 7, 2, 3, 1},
+	.larbid_remap = {{0}, {4}, {5}, {6}, {7}, {2}, {3}, {1}},
 };
 
 static const struct of_device_id mtk_iommu_of_ids[] = {
diff --git a/drivers/iommu/mtk_iommu.h b/drivers/iommu/mtk_iommu.h
index cf53f5e80d22..46d0d47b22e1 100644
--- a/drivers/iommu/mtk_iommu.h
+++ b/drivers/iommu/mtk_iommu.h
@@ -17,6 +17,9 @@
 #include <linux/spinlock.h>
 #include <soc/mediatek/smi.h>
 
+#define MTK_LARB_COM_MAX	8
+#define MTK_LARB_SUBCOM_MAX	4
+
 struct mtk_iommu_suspend_reg {
 	union {
 		u32			standard_axi_mode;/* v1 */
@@ -41,7 +44,7 @@ struct mtk_iommu_plat_data {
 	enum mtk_iommu_plat m4u_plat;
 	u32                 flags;
 	u32                 inv_sel_reg;
-	unsigned char       larbid_remap[MTK_LARB_NR_MAX];
+	unsigned char       larbid_remap[MTK_LARB_COM_MAX][MTK_LARB_SUBCOM_MAX];
 };
 
 struct mtk_iommu_domain;
-- 
2.18.0