[PATCH v2 4/5] clk: mediatek: Add configurable enable control to mtk_pll_data

[Weiyi Lu]

On Tue, 2020-08-11 at 15:28 +0800, Nicolas Boichat wrote:
> On Tue, Aug 11, 2020 at 2:43 PM Weiyi Lu <weiyi.lu at mediatek.com> wrote:
> > [...]
> > > > +       writel(r, pll->en_addr);
> > > >
> > > >         r = readl(pll->pwr_addr) | CON0_ISO_EN;
> > > >         writel(r, pll->pwr_addr);
> > > > @@ -327,6 +327,10 @@ static struct clk *mtk_clk_register_pll(const struct mtk_pll_data *data,
> > > >                 pll->tuner_addr = base + data->tuner_reg;
> > > >         if (data->tuner_en_reg)
> > > >                 pll->tuner_en_addr = base + data->tuner_en_reg;
> > > > +       if (data->en_reg)
> > > > +               pll->en_addr = base + data->en_reg;
> > > > +       else
> > > > +               pll->en_addr = pll->base_addr + REG_CON0;
> > >
> > > Don't you need to set pll->data->pll_en_bit to CON0_BASE_EN here?
> > > (which probably means that you need to add a pll->en_bit field to
> > > struct mtk_clk_pll)
> > >
> >
> > Because all mtk_clk_pll data are static variables, en_bit would be 0 if
> > NO value assigned.
> 
> Wow, you're right, but this is a little bit subtle. I wonder if it's
> worth adding a small comment? (either here or in struct mtk_pll_data)

OK, I'll add comment for en_bit