[PATCH RFC net-next 0/5] net: dsa: MT7530: Convert to PHYLINK and add support for port 5

René van Dorst opensource at vdorst.com
Mon Jun 24 07:52:46 PDT 2019

Here by I am sending my current patches for review.
I want to know if I am on the right track.

1. 0001-net-dsa-mt7530-Convert-to-PHYLINK-API.patch
   This patch converts mt7530 to PHYLINK API.
2. 0002-dt-bindings-net-dsa-mt7530-Add-support-for-port-5.patch
3. 0003-net-dsa-mt7530-Add-support-for-port-5.patch
   These 2 patches adding support for port 5 of the switch.

4. 0004-dt-bindings-net-dsa-mt7530-Add-mediatek-ephy-handle-.patch
5. 0005-net-dsa-mt7530-Add-mediatek-ephy-handle-to-isolate-e.patch
   These 2 patches adding property "mediatek,ephy-handle".
   When set, it puts the external phy in isolation mode.
   This allows the switch PHY of port 0/4 to interface with 2nd GMAC of
   the SOC. The external phy, 2nd GMAC and switch port 5 shares the same
   MII bus.

FWIW: Also working on converting the mediatek ethernet driver to PHYLINK.
This need a bit more work duo to the SGMII work and support hardware which 
I don't have.

René van Dorst (5):
  net: dsa: mt7530: Convert to PHYLINK API
  dt-bindings: net: dsa: mt7530: Add support for port 5
  net: dsa: mt7530: Add support for port 5
  dt-bindings: net: dsa: mt7530: Add mediatek,ephy-handle to isolate
    ext. phy
  net: dsa: mt7530: Add mediatek,ephy-handle to isolate external phy

 .../devicetree/bindings/net/dsa/mt7530.txt    | 329 ++++++++++++++++
 drivers/net/dsa/mt7530.c                      | 366 +++++++++++++++---
 drivers/net/dsa/mt7530.h                      |  39 ++
 3 files changed, 688 insertions(+), 46 deletions(-)


More information about the Linux-mediatek mailing list