[PATCH net-next 2/2] net: dsa: mt7530: Add MT7621 TRGMII mode support

René van Dorst opensource at vdorst.com
Sun Jun 16 11:20:10 PDT 2019


MT7621 internal MT7530 switch also supports TRGMII mode.
TRGMII speed is 1200MBit.

Signed-off-by: René van Dorst <opensource at vdorst.com>
---
 drivers/net/dsa/mt7530.c | 15 +++++++++++++--
 1 file changed, 13 insertions(+), 2 deletions(-)

diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
index c7d352da5448..88de4e880417 100644
--- a/drivers/net/dsa/mt7530.c
+++ b/drivers/net/dsa/mt7530.c
@@ -435,11 +435,20 @@ mt7530_pad_clk_setup(struct dsa_switch *ds, int mode)
 		trgint = 0;
 		ncpo1 = 0x0c80;
 		ssc_delta = 0x87;
+
+		/* Port 6 delay settings RGMII central align */
+		mt7530_rmw(priv, MT7530_TRGMII_TXCTRL, BIT(30) | BIT(28), 0);
+		mt7530_write(priv, MT7530_TRGMII_TCK_CTRL, 0x0855);
 		break;
 	case PHY_INTERFACE_MODE_TRGMII:
 		trgint = 1;
-		ncpo1 = 0x1400;
+		/* PLL frequency: MT7621 150MHz, other 162.5MHz */
+		ncpo1 = (priv->id == ID_MT7621 ? 0x0780 : 0x1400);
 		ssc_delta = 0x57;
+
+		/* Port 6 delay settings TRGMII central align */
+		mt7530_rmw(priv, MT7530_TRGMII_TXCTRL, 0, BIT(30));
+		mt7530_write(priv, MT7530_TRGMII_TCK_CTRL, 0x0055);
 		break;
 	default:
 		dev_err(priv->dev, "xMII mode %d not supported\n", mode);
@@ -507,7 +516,9 @@ mt7530_pad_clk_setup(struct dsa_switch *ds, int mode)
 			mt7530_rmw(priv, MT7530_TRGMII_RD(i),
 				   RD_TAP_MASK, RD_TAP(16));
 	else
-		mt7623_trgmii_set(priv, GSW_INTF_MODE, INTF_MODE_TRGMII);
+		if (priv->id != ID_MT7621)
+			mt7623_trgmii_set(priv, GSW_INTF_MODE,
+					  INTF_MODE_TRGMII);
 
 	return 0;
 }
-- 
2.20.1




More information about the Linux-mediatek mailing list