[PATCH] dt-bindings: serial: add documentation for Rx in-band wakeup support

Claire Chang tientzu at chromium.org
Tue Jun 11 05:15:10 PDT 2019


To support Rx in-band wakeup, one must create an interrupt specifier with
edge sensitivity on Rx pin and an addtional pinctrl to reconfigure Rx pin
to normal GPIO in sleep state. Driver will switch to sleep mode pinctrl and
enable irq wake before suspend and restore to default settings when
resuming.

Signed-off-by: Claire Chang <tientzu at chromium.org>
---
Resending this patch since I forgot to cc device tree maintainers/mailing list.
The 2/2 patch in this series[1] is already in tty-next[2].

[1] https://patchwork.kernel.org/patch/10962299/
[2] https://git.kernel.org/pub/scm/linux/kernel/git/gregkh/tty.git/log/?h=tty-testing

 .../devicetree/bindings/serial/mtk-uart.txt         | 13 +++++++++++--
 1 file changed, 11 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/serial/mtk-uart.txt b/Documentation/devicetree/bindings/serial/mtk-uart.txt
index bcfb13194f16..3488b6e24e0c 100644
--- a/Documentation/devicetree/bindings/serial/mtk-uart.txt
+++ b/Documentation/devicetree/bindings/serial/mtk-uart.txt
@@ -21,7 +21,12 @@ Required properties:
 
 - reg: The base address of the UART register bank.
 
-- interrupts: A single interrupt specifier.
+- interrupts or interrupts-extended:
+  index 0: an interrupt specifier for the UART controller itself
+  index 1: optional, an interrupt specifier with edge sensitivity on Rx pin to
+           support Rx in-band wake up. If one would like to use this feature,
+           one must create an addtional pinctrl to reconfigure Rx pin to normal
+           GPIO before suspend.
 
 - clocks : Must contain an entry for each entry in clock-names.
   See ../clocks/clock-bindings.txt for details.
@@ -37,7 +42,11 @@ Example:
 	uart0: serial at 11006000 {
 		compatible = "mediatek,mt6589-uart", "mediatek,mt6577-uart";
 		reg = <0x11006000 0x400>;
-		interrupts = <GIC_SPI 51 IRQ_TYPE_LEVEL_LOW>;
+		interrupts-extended = <&sysirq GIC_SPI 51 IRQ_TYPE_LEVEL_LOW>,
+				      <&gpio 121 IRQ_TYPE_EDGE_FALLING>;
 		clocks = <&uart_clk>, <&bus_clk>;
 		clock-names = "baud", "bus";
+		pinctrl-names = "default", "sleep";
+		pinctrl-0 = <&uart_pin>;
+		pinctrl-1 = <&uart_pin_sleep>;
 	};
-- 
2.22.0.rc2.383.gf4fbbf30c2-goog




More information about the Linux-mediatek mailing list