[PATCH v3 2/4] mtd: rawnand: mtk: Improve data sampling timing for read cycle
miquel.raynal at bootlin.com
Mon Jun 3 01:04:46 PDT 2019
On Tue, 2019-05-07 at 10:25:39 UTC, Xiaolei Li wrote:
> Currently, we expand RE# low level time by choosing the max value
> between RE# pulse width and RE# access time, and sample data at the
> rising edge of RE#.
> Then, if RE# access time is bigger than RE# pulse width, the real
> read cycle time may be more than NAND SPEC required. This makes
> read performance be worse than that expected.
> This patch improves data sampling timing by calculating RE# low level
> time according to RE# pulse width. If RE# access time is bigger than
> RE# pulse width, then delay sampling data timing.
> The result of contrast test base on MT2712 evaluat board is as follow.
> nand: Micron MT29F16G08ADBCAH4
> nand: 2048 MiB, SLC, erase size: 256 KiB, page size: 4096, OOB size: 224
> NFI 2x clock rate: 124800000 HZ.
> Read speed without this patch:
> mtd_speedtest: page read speed is 14012 KiB/s
> mtd_speedtest: 2 page read speed is 14860 KiB/s
> Read speed with this patch:
> mtd_speedtest: page read speed is 18724 KiB/s
> mtd_speedtest: 2 page read speed is 18713 KiB/s
> Signed-off-by: Xiaolei Li <xiaolei.li at mediatek.com>
> Reviewed-by: Miquel Raynal <miquel.raynal at bootlin.com>
Applied to https://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux.git nand/next, thanks.
More information about the Linux-mediatek