[PATCH 05/11] dt-bindings: phy-mtk-tphy: add the properties about address mapping

Chunfeng Yun chunfeng.yun at mediatek.com
Fri Aug 23 00:00:12 PDT 2019


Add three required properties about the address mapping, including
'#address-cells', '#size-cells' and 'ranges'

Signed-off-by: Chunfeng Yun <chunfeng.yun at mediatek.com>
---
 Documentation/devicetree/bindings/phy/phy-mtk-tphy.txt | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/Documentation/devicetree/bindings/phy/phy-mtk-tphy.txt b/Documentation/devicetree/bindings/phy/phy-mtk-tphy.txt
index ed9a2641f204..e162af66741e 100644
--- a/Documentation/devicetree/bindings/phy/phy-mtk-tphy.txt
+++ b/Documentation/devicetree/bindings/phy/phy-mtk-tphy.txt
@@ -14,6 +14,16 @@ Required properties (controller (parent) node):
 		  make use of "mediatek,generic-tphy-v1" on mt2701 instead and
 		  "mediatek,generic-tphy-v2" on mt2712 instead.
 
+- #address-cells:	the number of cells used to represent physical
+		base addresses.
+- #size-cells:	the number of cells used to represent the size of an address.
+- ranges:	the address mapping relationship to the parent, defined with
+		- empty value: if optional 'reg' is used.
+		- non-empty value: if optional 'reg' is not used. should set
+			the child's base address to 0, the physical address
+			within parent's address space, and the length of
+			the address map.
+
 Required nodes	: a sub-node is required for each port the controller
 		  provides. Address range information including the usual
 		  'reg' property is used inside these nodes to describe
-- 
2.23.0




More information about the Linux-mediatek mailing list