[PATCH 04/11] dt-bindings: phy-mtk-tphy: add a new reference clock

Chunfeng Yun chunfeng.yun at mediatek.com
Fri Aug 23 00:00:11 PDT 2019


Usually the digital and anolog phys use the same reference clock,
but on some platforms, they are separated, so add another optional
clock to support it.
In order to keep the clock names consistent with PHY IP's, use
the da_ref for anolog phy and ref clock for digital phy.

Signed-off-by: Chunfeng Yun <chunfeng.yun at mediatek.com>
---
 Documentation/devicetree/bindings/phy/phy-mtk-tphy.txt | 7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/phy/phy-mtk-tphy.txt b/Documentation/devicetree/bindings/phy/phy-mtk-tphy.txt
index dbc143ed5999..ed9a2641f204 100644
--- a/Documentation/devicetree/bindings/phy/phy-mtk-tphy.txt
+++ b/Documentation/devicetree/bindings/phy/phy-mtk-tphy.txt
@@ -41,9 +41,12 @@ Optional properties (PHY_TYPE_USB2 port (child) node):
 - clocks	: a list of phandle + clock-specifier pairs, one for each
 		  entry in clock-names
 - clock-names	: may contain
-		  "ref": 48M reference clock for HighSpeed anolog phy; and 26M
-			reference clock for SuperSpeed anolog phy, sometimes is
+		  "ref": 48M reference clock for HighSpeed (digital) phy; and 26M
+			reference clock for SuperSpeed (digital) phy, sometimes is
 			24M, 25M or 27M, depended on platform.
+		  "da_ref": the reference clock of anolog phy, used if the clocks
+			of anolog and digital phys are separated, otherwise uses
+			"ref" clock only if need.
 
 - mediatek,eye-src	: u32, the value of slew rate calibrate
 - mediatek,eye-vrt	: u32, the selection of VRT reference voltage
-- 
2.23.0




More information about the Linux-mediatek mailing list