[PATCH v8 00/11] add USB GPIO based connection detection driver

Linus Walleij linus.walleij at linaro.org
Mon Aug 5 03:06:56 PDT 2019


On Wed, Jul 24, 2019 at 10:51 AM Chunfeng Yun <chunfeng.yun at mediatek.com> wrote:

> Because the USB Connector is introduced and the requirement of
> usb-connector.txt binding, the old way using extcon to support
> USB Dual-Role switch is now deprecated, meanwhile there is no
> available common driver when use Type-B connector, typically
> using an input GPIO to detect USB ID pin.

However while this was going on,
drivers/extcon/extcon-fsa9480.c was merged and that detects
not only GPIO on the USB port but multiplexed usecases such
as UART over the USB micro PHY (and no that UART is not
a USB UART, but an actual RX/TX over D-/D+).

That driver also measure a whole slew of funny resistance
values on the ID pin, that is how it does its job.

But for just "hey I'm plugged in" we can surely keep this
ID on GPIO detection in the USB subsystem.

I just get a bit insecure about how we should ideally
handle these "funny-PHY's".

Yours,
Linus Walleij



More information about the Linux-mediatek mailing list