[PATCH v1 08/19] arm: dts: mt7623: enable three available UARTs on bananapi-r2

sean.wang at mediatek.com sean.wang at mediatek.com
Fri Feb 23 02:16:28 PST 2018


From: Sean Wang <sean.wang at mediatek.com>

On bpi-r2 board, totally there're four UARTs which we usually called
uart[0-3] helpful to extend slow-I/O devices. Among those ones, uart2 has
dedicated pin slot which is used to console log. uart[0-1] appear at the
40-pins connector and uart3 has no pinout, but just has test points (TP47
for TX and TP48 for RX, respectively) nearby uart2, but we don't enable
uart3 in the patch. The missing pinctrl is also being supplemented for
those newly added devices.

Signed-off-by: Sean Wang <sean.wang at mediatek.com>
---
 arch/arm/boot/dts/mt7623n-bananapi-bpi-r2.dts | 13 +++++++++++--
 1 file changed, 11 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/mt7623n-bananapi-bpi-r2.dts b/arch/arm/boot/dts/mt7623n-bananapi-bpi-r2.dts
index 8ef91d6..6b760be 100644
--- a/arch/arm/boot/dts/mt7623n-bananapi-bpi-r2.dts
+++ b/arch/arm/boot/dts/mt7623n-bananapi-bpi-r2.dts
@@ -470,6 +470,13 @@
 				 <MT7623_PIN_82_UTXD1_FUNC_UTXD1>;
 		};
 	};
+
+	uart2_pins_a: uart at 2 {
+		pins_dat {
+			pinmux = <MT7623_PIN_14_GPIO14_FUNC_URXD2>,
+				 <MT7623_PIN_15_GPIO15_FUNC_UTXD2>;
+		};
+	};
 };
 
 &pwm {
@@ -515,16 +522,18 @@
 &uart0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&uart0_pins_a>;
-	status = "disabled";
+	status = "okay";
 };
 
 &uart1 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&uart1_pins_a>;
-	status = "disabled";
+	status = "okay";
 };
 
 &uart2 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&uart2_pins_a>;
 	status = "okay";
 };
 
-- 
2.7.4




More information about the Linux-mediatek mailing list