[PATCH v2 06/16] arm64: dts: mt7622: add cpufreq related device nodes
Viresh Kumar
viresh.kumar at linaro.org
Tue Feb 6 22:18:37 PST 2018
On 07-02-18, 14:16, Sean Wang wrote:
> On Wed, 2018-02-07 at 09:03 +0530, Viresh Kumar wrote:
> > On 06-02-18, 17:52, sean.wang at mediatek.com wrote:
> > > cpus {
> > > #address-cells = <2>;
> > > #size-cells = <0>;
> > > @@ -26,6 +70,10 @@
> > > device_type = "cpu";
> > > compatible = "arm,cortex-a53", "arm,armv8";
> > > reg = <0x0 0x0>;
> > > + clocks = <&infracfg CLK_INFRA_MUX1_SEL>,
> > > + <&apmixedsys CLK_APMIXED_MAIN_CORE_EN>;
> > > + clock-names = "cpu", "intermediate";
> > > + operating-points-v2 = <&cpu_opp_table>;
> > > enable-method = "psci";
> > > clock-frequency = <1300000000>;
> > > };
> > > @@ -34,6 +82,7 @@
> > > device_type = "cpu";
> > > compatible = "arm,cortex-a53", "arm,armv8";
> > > reg = <0x0 0x1>;
> > > + operating-points-v2 = <&cpu_opp_table>;
> > > enable-method = "psci";
> > > clock-frequency = <1300000000>;
> > > };
> >
> > Sorry for not picking this earlier, but you should probably add the same clock
> > related properties for both cpu nodes here. Things will break if CPU1 is used by
> > the cpufreq core to bring the cpufreq policy online.
> >
> > This can happen if cpufreq driver is a module, CPU0 is hotplugged out and then
> > the cpufreq driver is inserted.
> >
>
> mt7622 cpu0 does not support hotplug. do I still need to add same clock
> related properties for both cpu nodes here?
Normally we should always add these properties to all the CPUs, as that's the
real scenario hardware configuration wise.
But I am not sure if something else will break if you don't provide clocks in
CPU1.
@Rob @Mark: What do you suggest ?
--
viresh
More information about the Linux-mediatek
mailing list