[PATCH v1 1/2] mtd: nand: mediatek: update DT bindings
Matthias Brugger
matthias.bgg at gmail.com
Thu May 11 01:08:49 PDT 2017
On 11/05/17 09:25, Xiaolei Li wrote:
> Add MT2712 NAND Flash Controller dt bindings documentation.
>
> Signed-off-by: Xiaolei Li <xiaolei.li at mediatek.com>
> ---
> Documentation/devicetree/bindings/mtd/mtk-nand.txt | 7 +++++--
> 1 file changed, 5 insertions(+), 2 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/mtd/mtk-nand.txt b/Documentation/devicetree/bindings/mtd/mtk-nand.txt
> index 069c192..6482650 100644
> --- a/Documentation/devicetree/bindings/mtd/mtk-nand.txt
> +++ b/Documentation/devicetree/bindings/mtd/mtk-nand.txt
> @@ -12,7 +12,9 @@ tree nodes.
>
> The first part of NFC is NAND Controller Interface (NFI) HW.
> Required NFI properties:
> -- compatible: Should be "mediatek,mtxxxx-nfc".
> +- compatible: Should be "mediatek,mt{SoC name}-nfc".
> + So far, the supported are
> + "mediatek,mt2701-nfc", "mediatek,mt2712-nfc".
Better would be:
Should be one of "mediatek,mt2701-nfc", "mediatek,mt2712-nfc".
> - reg: Base physical address and size of NFI.
> - interrupts: Interrupts of NFI.
> - clocks: NFI required clocks.
> @@ -141,7 +143,8 @@ Example:
> ==============
>
> Required BCH properties:
> -- compatible: Should be "mediatek,mtxxxx-ecc".
> +- compatible: Should be "mediatek,mt{SoC name}-ecc". So far, the supported
> + are "mediatek,mt2701-ecc", "mediatek,mt2712-ecc".
Same here.
> - reg: Base physical address and size of ECC.
> - interrupts: Interrupts of ECC.
> - clocks: ECC required clocks.
> --
> 1.9.1
>
> ************* Email Confidentiality Notice
> ********************
> The information contained in this e-mail message (including any
> attachments) may be confidential, proprietary, privileged, or otherwise
> exempt from disclosure under applicable laws. It is intended to be
> conveyed only to the designated recipient(s). Any use, dissemination,
> distribution, printing, retaining or copying of this e-mail (including its
> attachments) by unintended recipient(s) is strictly prohibited and may
> be unlawful. If you are not an intended recipient of this e-mail, or believe
>
> that you have received this e-mail in error, please notify the sender
> immediately (by replying to this e-mail), delete any and all copies of
> this e-mail (including any attachments) from your system, and do not
> disclose the content of this e-mail to any other person. Thank
> you!
>
Please fix your mail setup to not send this footer.
Regards,
Matthias
More information about the Linux-mediatek
mailing list