[PATCH 6/6] pinctrl: mt8173: set GPIO16 to usb iddig mode

[chunfeng yun]

Hi,

On Wed, 2016-05-11 at 11:32 -0700, Hongzhou Yang wrote:
> On Wed, 2016-05-11 at 13:56 +0200, Linus Walleij wrote:
> > On Tue, May 10, 2016 at 10:23 AM, Chunfeng Yun
> > <chunfeng.yun at mediatek.com> wrote:
> > 
> > > the default mode of GPIO16 pin is gpio, when set EINT16 to
> > > IRQ_TYPE_LEVEL_HIGH, no interrupt is triggered, it can be
> > > fixed when set its default mode as usb iddig.
> > >
> > > Signed-off-by: Chunfeng Yun <chunfeng.yun at mediatek.com>
> > 
> 
> Chunfeng, GPIO16 can be used as EINT16 mode, but the pinmux should be 0.
> If you want to set its default mode to iddig, you should set it in dts.
> 
I set it in DTS, but it didn't work, because when usb driver requested
IRQ, pinmux was switched back to default mode set by
MTK_EINT_FUNCTION().


> Yours,
> Hongzhou
>