[PATCH V2 02/22] net-next: mediatek: fix gigabit and flow control advertisement

John Crispin john at phrozen.org
Mon May 9 03:03:54 PDT 2016


The current code will not setup the PHYs advertisement features correctly.
Fix this and properly advertise Gigabit features and properly handle
asymmetric pause frames.

Signed-off-by: John Crispin <john at phrozen.org>
---
 drivers/net/ethernet/mediatek/mtk_eth_soc.c |   16 ++++++++++++++--
 1 file changed, 14 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/mediatek/mtk_eth_soc.c b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
index 28f169f..a76aec20 100644
--- a/drivers/net/ethernet/mediatek/mtk_eth_soc.c
+++ b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
@@ -133,6 +133,8 @@ static int mtk_mdio_read(struct mii_bus *bus, int phy_addr, int phy_reg)
 static void mtk_phy_link_adjust(struct net_device *dev)
 {
 	struct mtk_mac *mac = netdev_priv(dev);
+	u16 lcl_adv, rmt_adv = 0;
+	u8 flowctrl;
 	u32 mcr = MAC_MCR_MAX_RX_1536 | MAC_MCR_IPG_CFG |
 		  MAC_MCR_FORCE_MODE | MAC_MCR_TX_EN |
 		  MAC_MCR_RX_EN | MAC_MCR_BACKOFF_EN |
@@ -154,7 +156,16 @@ static void mtk_phy_link_adjust(struct net_device *dev)
 		mcr |= MAC_MCR_FORCE_DPX;
 
 	if (mac->phy_dev->pause)
-		mcr |= MAC_MCR_FORCE_RX_FC | MAC_MCR_FORCE_TX_FC;
+		rmt_adv = LPA_PAUSE_CAP;
+	if (mac->phy_dev->asym_pause)
+		rmt_adv |= LPA_PAUSE_ASYM;
+
+	lcl_adv = mii_advertise_flowctrl(FLOW_CTRL_RX | FLOW_CTRL_TX);
+	flowctrl = mii_resolve_flowctrl_fdx(lcl_adv, rmt_adv);
+	if (flowctrl & FLOW_CTRL_TX)
+		mcr |= MAC_MCR_FORCE_TX_FC;
+	if (flowctrl & FLOW_CTRL_RX)
+		mcr |= MAC_MCR_FORCE_RX_FC;
 
 	mtk_w32(mac->hw, mcr, MTK_MAC_MCR(mac->id));
 
@@ -236,7 +247,8 @@ static int mtk_phy_connect(struct mtk_mac *mac)
 	mac->phy_dev->autoneg = AUTONEG_ENABLE;
 	mac->phy_dev->speed = 0;
 	mac->phy_dev->duplex = 0;
-	mac->phy_dev->supported &= PHY_BASIC_FEATURES;
+	mac->phy_dev->supported &= PHY_GBIT_FEATURES | SUPPORTED_Pause |
+				   ~SUPPORTED_Asym_Pause;
 	mac->phy_dev->advertising = mac->phy_dev->supported |
 				    ADVERTISED_Autoneg;
 	phy_start_aneg(mac->phy_dev);
-- 
1.7.10.4




More information about the Linux-mediatek mailing list