[PATCH V4 2/4] net-next: mediatek: fix gigabit and flow control advertisement

John Crispin john at phrozen.org
Fri Jun 3 01:17:07 PDT 2016


The current code will not setup the PHYs advertisement features correctly.
Fix this and properly advertise Gigabit features and properly handle
asymmetric pause frames.

Signed-off-by: Sean Wang <keyhaede at gmail.com>
Signed-off-by: John Crispin <john at phrozen.org>
---
Changes in V4
* set SUPPORTED_Asym_Pause rather than clearing it
* add debug code
* only setup asym if we are in full duplex

 drivers/net/ethernet/mediatek/mtk_eth_soc.c |   30 +++++++++++++++++++++++----
 1 file changed, 26 insertions(+), 4 deletions(-)

diff --git a/drivers/net/ethernet/mediatek/mtk_eth_soc.c b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
index 28f169f..b0652f6 100644
--- a/drivers/net/ethernet/mediatek/mtk_eth_soc.c
+++ b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
@@ -133,6 +133,8 @@ static int mtk_mdio_read(struct mii_bus *bus, int phy_addr, int phy_reg)
 static void mtk_phy_link_adjust(struct net_device *dev)
 {
 	struct mtk_mac *mac = netdev_priv(dev);
+	u16 lcl_adv = 0, rmt_adv = 0;
+	u8 flowctrl;
 	u32 mcr = MAC_MCR_MAX_RX_1536 | MAC_MCR_IPG_CFG |
 		  MAC_MCR_FORCE_MODE | MAC_MCR_TX_EN |
 		  MAC_MCR_RX_EN | MAC_MCR_BACKOFF_EN |
@@ -150,11 +152,30 @@ static void mtk_phy_link_adjust(struct net_device *dev)
 	if (mac->phy_dev->link)
 		mcr |= MAC_MCR_FORCE_LINK;
 
-	if (mac->phy_dev->duplex)
+	if (mac->phy_dev->duplex) {
 		mcr |= MAC_MCR_FORCE_DPX;
 
-	if (mac->phy_dev->pause)
-		mcr |= MAC_MCR_FORCE_RX_FC | MAC_MCR_FORCE_TX_FC;
+		if (mac->phy_dev->pause)
+			rmt_adv = LPA_PAUSE_CAP;
+		if (mac->phy_dev->asym_pause)
+			rmt_adv |= LPA_PAUSE_ASYM;
+
+		if (mac->phy_dev->advertising & ADVERTISED_Pause)
+			lcl_adv |= ADVERTISE_PAUSE_CAP;
+		if (mac->phy_dev->advertising & ADVERTISED_Asym_Pause)
+			lcl_adv |= ADVERTISE_PAUSE_ASYM;
+
+		flowctrl = mii_resolve_flowctrl_fdx(lcl_adv, rmt_adv);
+
+		if (flowctrl & FLOW_CTRL_TX)
+			mcr |= MAC_MCR_FORCE_TX_FC;
+		if (flowctrl & FLOW_CTRL_RX)
+			mcr |= MAC_MCR_FORCE_RX_FC;
+
+		netif_dbg(mac->hw, link, dev, "rx pause %s, tx pause %s\n",
+			  flowctrl & FLOW_CTRL_RX ? "enabled" : "disabled",
+			  flowctrl & FLOW_CTRL_TX ? "enabled" : "disabled");
+	}
 
 	mtk_w32(mac->hw, mcr, MTK_MAC_MCR(mac->id));
 
@@ -236,7 +257,8 @@ static int mtk_phy_connect(struct mtk_mac *mac)
 	mac->phy_dev->autoneg = AUTONEG_ENABLE;
 	mac->phy_dev->speed = 0;
 	mac->phy_dev->duplex = 0;
-	mac->phy_dev->supported &= PHY_BASIC_FEATURES;
+	mac->phy_dev->supported &= PHY_GBIT_FEATURES | SUPPORTED_Pause |
+				   SUPPORTED_Asym_Pause;
 	mac->phy_dev->advertising = mac->phy_dev->supported |
 				    ADVERTISED_Autoneg;
 	phy_start_aneg(mac->phy_dev);
-- 
1.7.10.4




More information about the Linux-mediatek mailing list