[PATCH V4 4/4] net-next: mediatek: properly handle RGMII modes

John Crispin john at phrozen.org
Fri Jun 3 01:17:09 PDT 2016


If an external Gigabit PHY is connected to either of the MACs we need to
be able to tell the PHY to use a delay. Not doing so will result in heavy
packet loss and/or data corruption when using PHYs such as the IC+ IP1001.
We tell the PHY which MII delay mode to use via the devictree.

The ethernet driver needs to be adapted to handle all 3 rgmii-*id modes
in the same way as normal rgmii when setting up the MAC.

Reviewed-by: Andrew Lunn <andrew at lunn.ch>
Signed-off-by: John Crispin <john at phrozen.org>
---
 drivers/net/ethernet/mediatek/mtk_eth_soc.c |    3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/net/ethernet/mediatek/mtk_eth_soc.c b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
index 231d284..4763252 100644
--- a/drivers/net/ethernet/mediatek/mtk_eth_soc.c
+++ b/drivers/net/ethernet/mediatek/mtk_eth_soc.c
@@ -236,6 +236,9 @@ static int mtk_phy_connect(struct mtk_mac *mac)
 		return -ENODEV;
 
 	switch (of_get_phy_mode(np)) {
+	case PHY_INTERFACE_MODE_RGMII_TXID:
+	case PHY_INTERFACE_MODE_RGMII_RXID:
+	case PHY_INTERFACE_MODE_RGMII_ID:
 	case PHY_INTERFACE_MODE_RGMII:
 		ge_mode = 0;
 		break;
-- 
1.7.10.4




More information about the Linux-mediatek mailing list