[PATCH v2 1/3] PM/OPP: Don't skip cpu_dev->id when setting up cpumask

Viresh Kumar viresh.kumar at linaro.org
Sun Dec 27 19:11:23 PST 2015


On 27-12-15, 14:21, Pi-Cheng Chen wrote:
> Don't skip cpu_dev->id when setting up cpumask for CPUs that share the
> same OPP table. This might be helpful when handling cpumask without the
> original CPU bitfield set.
> 
> Signed-off-by: Pi-Cheng Chen <pi-cheng.chen at linaro.org>
> ---
>  drivers/base/power/opp/cpu.c | 4 ----
>  1 file changed, 4 deletions(-)
> 
> diff --git a/drivers/base/power/opp/cpu.c b/drivers/base/power/opp/cpu.c
> index 7b445e8..4914a0d 100644
> --- a/drivers/base/power/opp/cpu.c
> +++ b/drivers/base/power/opp/cpu.c
> @@ -214,7 +214,6 @@ EXPORT_SYMBOL_GPL(dev_pm_opp_of_cpumask_add_table);
>  /*
>   * Works only for OPP v2 bindings.
>   *
> - * cpumask should be already set to mask of cpu_dev->id.
>   * Returns -ENOENT if operating-points-v2 bindings aren't supported.
>   */
>  int dev_pm_opp_of_get_sharing_cpus(struct device *cpu_dev, cpumask_var_t cpumask)
> @@ -235,9 +234,6 @@ int dev_pm_opp_of_get_sharing_cpus(struct device *cpu_dev, cpumask_var_t cpumask
>  		goto put_cpu_node;
>  
>  	for_each_possible_cpu(cpu) {
> -		if (cpu == cpu_dev->id)
> -			continue;
> -
>  		tcpu_dev = get_cpu_device(cpu);
>  		if (!tcpu_dev) {
>  			dev_err(cpu_dev, "%s: failed to get cpu%d device\n",

Not this way. You should just set 'cpumask' to cpumask of cpu_dev->id
at the top of the function.

-- 
viresh



More information about the Linux-mediatek mailing list