[PATCH] mmc: mediatek: change some dev_err to dev_dbg
Chaotian Jing
chaotian.jing at mediatek.com
Tue Dec 1 04:12:34 PST 2015
there are too many error logs shown when use CMD21/CMD19 to do tune,
and it will appear at each resume time, print out so many logs to the
uart console cost too mush time. so change it to dev_dbg.
Signed-off-by: Chaotian Jing <chaotian.jing at mediatek.com>
---
drivers/mmc/host/mtk-sd.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/mmc/host/mtk-sd.c b/drivers/mmc/host/mtk-sd.c
index 39568cc..34d23b8 100644
--- a/drivers/mmc/host/mtk-sd.c
+++ b/drivers/mmc/host/mtk-sd.c
@@ -972,7 +972,7 @@ static bool msdc_data_xfer_done(struct msdc_host *host, u32 events,
if ((events & MSDC_INT_XFER_COMPL) && (!stop || !stop->error)) {
data->bytes_xfered = data->blocks * data->blksz;
} else {
- dev_err(host->dev, "interrupt events: %x\n", events);
+ dev_dbg(host->dev, "interrupt events: %x\n", events);
msdc_reset_hw(host);
host->error |= REQ_DAT_ERR;
data->bytes_xfered = 0;
@@ -982,10 +982,10 @@ static bool msdc_data_xfer_done(struct msdc_host *host, u32 events,
else if (events & MSDC_INT_DATCRCERR)
data->error = -EILSEQ;
- dev_err(host->dev, "%s: cmd=%d; blocks=%d",
+ dev_dbg(host->dev, "%s: cmd=%d; blocks=%d",
__func__, mrq->cmd->opcode, data->blocks);
- dev_err(host->dev, "data_error=%d xfer_size=%d\n",
- (int)data->error, data->bytes_xfered);
+ dev_dbg(host->dev, "data_error=%d xfer_size=%d\n",
+ (int)data->error, data->bytes_xfered);
}
msdc_data_xfer_next(host, mrq, data);
--
1.8.1.1.dirty
More information about the Linux-mediatek
mailing list