[PATCH v2 05/13] i3c: master: Add support for devices using SETAASA

[Frank Li]

On Thu, Apr 09, 2026 at 04:27:35PM +0530, Akhil R wrote:
> Add support for devices using SETAASA, such as SPD5118 and SPD5108
> attached to DDR5 memory modules that do not support ENTDAA. Follow the
> guidelines proposed by the MIPI Discovery and Configuration
> Specification[1] for discovering such devices.
>
> SETAASA (Set All Addresses to Static Address) differs from standard I3C
> address assignment that uses ENTDAA or SETDASA to assign dynamic
> addresses. Devices using SETAASA assign their pre-defined static
> addresses as their dynamic addresses during DAA, and it is not mandatory
> for these devices to implement standard CCC commands like GETPID, GETDCR,
> or GETBCR. For such devices, it is generally recommended to issue SETHID
> (specified by JEDEC JESD300) as a prerequisite for SETAASA to stop HID
> bit flipping.
>
> [1] https://www.mipi.org/mipi-disco-for-i3c-download
>
> Signed-off-by: Akhil R <akhilrajeev at nvidia.com>
> ---
>  drivers/i3c/master.c       | 73 +++++++++++++++++++++++++++++++++++++-
>  include/linux/i3c/ccc.h    |  1 +
>  include/linux/i3c/master.h | 17 +++++++++
>  3 files changed, 90 insertions(+), 1 deletion(-)
...
>
> @@ -498,6 +507,8 @@ struct i3c_master_controller_ops {
>  				  unsigned long dev_nack_retry_cnt);
>  };
>
> +#define I3C_ADDR_METHOD_SETDASA BIT(0)
> +#define I3C_ADDR_METHOD_SETAASA BIT(1)

This one should in include/dt-bindings/i3c/i3c.h

Frank
>